Operation, cont’d
5Volume control knob — Rotate this knob to adjust the audio volume (audio gain) for the amplified output. The volume control knob can be used as a master volume control for both audio outputs if all the audio inputs have the same level. There is no physical limit to this knob’s rotation. The Min or Max LED will light briefly when the knob has reached its functional minimum or maximum limit.
Audio gain/attenuation can be set per input via the switcher’s front panel controls or via
Input selection buttons and LEDs
Use these buttons to select the appropriate input source. LEDs next to each button indicate the format of the incoming video signal. Only the selected input’s LED lights. If the System 5cr Plus has learned commands, it may send IR commands (such as a display mode change command) to the projector when an input is selected.
6PC 1 and PC 2 — Press these buttons to select input 1 (PC 1 on the switcher’s front panel) or input 2 (PC 2 on the switcher’s rear panel), respectively. Both inputs accept only RGB
7Input 3 — This button corresponds to Input 3 (rear panel), which can be configured to accept audio and RGB, or
8Vid 1 and Vid 2 — Press these buttons to select input 4 (Vid 1) or input 5 (Vid 2), respectively. Both of these rear panel inputs can be configured to accept audio and either
Audio breakaway (the ability to separately switch audio and video signals from different inputs) is available only via the
SCP 100P
AAppendix
Specifications, Parts, Accessories, and Dimensions
Specifications
Included Parts
Accessories
Panel Dimensions
Template