Extron electronic MPX Plus 866 A manual Command/response table for IP SIS commands

PRELIMINARY

SIS™ Programming and Control, cont’d

Command/response table for IP SIS commands

Command	ASCII command	Response	Additional
	(host to switcher)	(switcher to host)	description
Set matrix name (location)	EX3)CN}	Ipn•X3)]
Read matrix name (location)	ECN}	X3)]
Reset matrix name to	E•CN}	Ipn•X3!]
factory default
Set time and date	EX3@CT}	IptX3@]
Read time and date	ECT}	X3#]
Set GMT offset	EX3$CZ}	IpzX3$]	The divider between
			hours and minutes is a
			period.
Read GMT offset	ECZ}	X3$]
Set Daylight Savings Time	EX3%CX}	IpxX3%]	Set the switcher to display
			the local time as Daylight
			Savings Time (+1 hour) in
			summer months.
Read Daylight Savings Time	ECX}	X3%]
Set IP address	EX3^CI}	IpiX3^]
Read IP address	ECI}	X3^]
Read hardware address	ECH}	X3&]
Read # of open connections	ECC}	X3*]
Set subnet mask	EX3^CS}	IpsX3^]
Read subnet mask	ECS}	X3^]
Set gateway IP address	EX3^CG}	IpgX3^]
Read gateway IP address	ECG}	X3^]
Set administrator password	EX3(CA}	Ipa•X3(]
Read administrator	ECA}	X3(]
password
Reset (clear) administrator	E•CA}	Ipa•X3(]
password
Set user password	EX3(CU}	Ipu•X3(]
Read user password	ECU}	X3(]
Reset (clear) user password	E•CU}	Ipu•X3(]
Set DHCP on or off	EX4^DH}	IdhX4^]
Read DHCP status	EDH}	X4^]
Set serial port parameters	EX4&*X4*,X4(,X5),X5!CP}	X4*,X4(,X5),X5!]
Read serial port parameters	EX4&CP}	CpnX4&•CcpX4*,X4(,X5),X5!]
Set serial port mode	EX4&*X5@CY}	CpnX4&•CtyX5@]

NAll serial ports are limited to the RS-232 protocol only.

Read serial port mode	EX4&CY}	X5@]
Set verbose mode	EX5#CV}	VrbX5#]
Read verbose mode	ECV}	X5#]
Read connection’s security	ECK	X5$]
level
Commit RAM to flash	E1FF}	NvrX5%]
memory
Check RAM	EFF}	X5%]
Configure current port	E0*Y7^TC}	Pti0*Y7^]
timeout
Read current port timeout	E0TC}	Y6*]
Configure global IP port	E1*Y7^TC}	Pti1*Y7^]
timeout
Read global IP port timeout	E1TC}	Y7^]

4-20 MPX Plus 866 A Media Presentation Matrix Switcher • SIS Programming and Control