Gigabyte GA-MA770T-UD3P user manual Supervisor Password, User Password

2-11	Set Supervisor/User Password
	CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
	MB Intelligent Tweaker(M.I.T.)		Load Fail-Safe Defaults
	Standard CMOS Features		Load Optimized Defaults
	Advanced BIOS Features		Set Supervisor Password
	Integrated Peripherals		Set User Password
	Enter Password:		Save & Exit Setup
	Power Management Setup
	PC Health Status		Exit Without Saving
ESC: Quit		: Select Item		F11: Save CMOS to BIOS
F8: Q-Flash		F10: Save & Exit Setup		F12: Load CMOS from BIOS
		Change/Set/Disable Password

Press <Enter> on this item and type the password with up to 8 characters and then press <Enter>. You will be requested to confirm the password. Type the password again and press <Enter>.

The BIOS Setup program allows you to specify two separate passwords:

Supervisor Password

When a system password is set and the Password Check item in Advanced BIOS Features is set to Setup, you must enter the supervisor password for entering BIOS Setup and making BIOS changes.

When the Password Check item is set to System, you must enter the supervisor password (or user password) at system startup and when entering BIOS Setup.

User Password

When the Password Check item is set to System, you must enter the supervisor password (or user password) at system startup to continue system boot. In BIOS Setup, you must enter the supervisor password if you wish to make changes to BIOS settings. The user password only allows you to view the BIOS settings but not to make changes.

To clear the password, press <Enter> on the password item and when requested for the password, press <Enter> again. The message "PASSWORD DISABLED" will appear, indicating the password has been cancelled.

- 55 - BIOS Setup