Gigabyte GA-K8VT800 user manual Load Optimized Defaults, Set Supervisor/User Password

English

2-10 Load Optimized Defaults

CMOS Setup Utility-Copyright (C) 1984-2004 Award Software

`	Standard CMOS Features	Top Performance
`	Advanced BIOS Features	Load Fail-Safe Defaults
`	Integrated Peripherals	Load Optimized Defaults
`	Power Management Setup	Set Supervisor Password
`	PnP/PCI Configurations	Load Optimized DefaultsSet(Y/N)?User PasswordN
`	PC Health Status	Save & Exit Setup
`	Frequency/Voltage Control	Exit Without Saving

Esc: Quit	KLJI: Select Item
F8: Q-Flash	F10: Save & Exit Setup
	Load Optimized Defaults

Selecting this field loads the factory defaults for BIOS and Chipset Features which the system automati- cally detects.

2-11	Set Supervisor/User Password
	CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
`	Standard CMOS Features	Top Performance
`	Advanced BIOS Features	Load Fail-Safe Defaults
`	Integrated Peripherals	Load Optimized Defaults
`	Power Management Setup	Set Supervisor Password
`	PnP/PCI ConfigurationsEnter Password:	Set User Password
`	PC Health Status	Save & Exit Setup
`	Frequency/Voltage Control	Exit Without Saving
Esc: Quit		KLJI: Select Item
F8: Q-Flash		F10: Save & Exit Setup
	Change/Set/Disable Password

When you select this function, the following message will appear at the center of the screen to assist you in creating a password.

Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the password. Type the password again and press <Enter>. You may also press <Esc> to abort the selection and not enter a password.

To disable password, just press <Enter> when you are prompted to enter password. A message "PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is disabled, the system will boot and you can enter Setup freely.

The BIOS Setup program allows you to specify two separate passwords:

SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access all BIOS Setup program function. When enabled, the Supervisor password is required for entering the BIOS Setup program and having full configuration fields, the User password is required to access only basic items.

If you select "System" at "Password Check" in Advance BIOS Features Menu, you will be prompted for the password every time the system is rebooted or any time you try to enter Setup Menu.

If you select "Setup" at "Password Check" in Advance BIOS Features Menu, you will be prompted only when you try to enter Setup.

GA-K8VT800 Motherboard - 44 -