Troubleshooting
If you encounter any trouble during boot up, please follow the troubleshooting procedures.
English
START
Turn off the power and unplug the AC power cable, then remove all of the
Please make sure motherboard & chassis are not short ?
No
Please make sure all jumper settings (such as CPU system bus speed, frequency ratio, voltage and etc) are set properly.
Yes
Check if the CPU cooling fan attached to CPU properly. ls CPU cooling fan power connected to CPU_FAN
properly?
Yes
Check if the memory install properly into the DIMM slot.
Yes
Insert the VGA card. Then plug in ATX power cable and turn on the system.
Yes | Please isolate |
| the short pin. |
Failure has been excluded.
No | Make sure the | |
jumper setting | ||
| ||
| are correct. |
Failure has been excluded.
Plug the CPU cooling fan power
No in the CPU fan 
connector. Plug
in the AC power connector.
Failure has been excluded.
Insert and push
No the memory 
module vertically into the DIMM slot.
Failure has been excluded. 
A
- 89 - | Appendix |