Clearing the program, Programming track numbers

1 CD5000/NLB(1-12) En 01.5.31 3:43 PM ページ9

				ADDITIONAL FUNCTIONS
HIGHLIGHT	SHUFFLE	FADE	Clearing the program
CD TEXT			1	If necessary press STOP 9 to stop program playing.
			1	If necessary press STOP 9 to stop program playing.
SCROLL			2	Press STOP 9 to clear the program.
PROG	EDIT	PEAK	2	Press STOP 9 to clear the program.
				y PROGRAM CLEARED scrolls through the display,
TIME				PROGRAM disappears and your program is cleared.
			Note: The program will also be cleared if you open the tray.

English

Programming track numbers

You can select a number of tracks and store these in the memory in the desired sequence. You can store any track more than once. At most, 30 tracks can be stored in the memory.

1Press PROG to start programming. y PROGRAM flashes.

Note: If you press PROG while playing a CD, the actual track will be added to the program.

2Press PREV. ∞ or NEXT § to select the desired track.

• Key in the number of a track with the digits 0–9on the remote control.

3Press PROG to store the track number.

y TRACK, TOTAL TIME, and the number of the programmed track is displayed. The number of programmed tracks is increased and the time of the track is added to the total time of the program.

4Repeat steps 2 and 3 for all tracks to be programmed.

5Press STOP 9 to end programming. y PROGRAM lights permamently.

•It is possible to review the program using the PREV. ∞ or NEXT §. You can add more tracks by pressing PROGRAM like you have done before.

6Press PLAY 2 to start program play.

Note: If you try to store more than 30 tracks PROGRAM FULL scrolls through the display.

Loudest passage searching

You can search for the loudest passage of a CD or program. This will help you in adjusting your recording device if required.

1If necessary press STOP 9 to stop CD play.

2Press PEAK to start searching.

y PEAK starts flashing. Searching may need a few minutes. Then 4 seconds of the loudest passage are played repeatedly.

•You can interrupt peak play by pressing PAUSE ;. Continue peak play by pressing PAUSE ; again.

3Press STOP 9 to stop playing.

• Press PLAY 2 to start CD play.

Time display

You can display time information which is stored on the CD.

While playing a CD or a program the number and elapsed time of the actual track, and TIME are displayed. If the disc contains CD-Text the display shows CD-Text information (see “CD-Text”).

•Press TIME several times to display:

y If the disc contains CD-Text, the number and elapsed time of the actual track, and TIME are displayed first.

y The number and remaining time of the actual track, and

REM TIME.

y The number of the actual track, the total elapsed time of the CD, and TOTAL TIME.

y The number of the actual track, the total remaining time of the CD, and TOTAL REM TIME.

Note: If you press TIME when the CD is not playing you may only display the total time of the CD.

ADDITIONAL FUNCTIONS