Gigabyte GA-945PLM-(D)S2 user manual Integrated Peripherals, Smart LAN

English

2-3	Integrated Peripherals
		CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
				Integrated Peripherals
	On-Chip Primary PCI IDE			[Enabled]		Item Help
	On-Chip SATA Mode			[Auto]		Menu Level`
x	PATA IDE Set to			Ch.0 Master/Slave
	SATA Port 0/2 Set to			Ch.2 Master/Slave
	SATA Port 1/3 Set to			Ch.3 Master/Slave
	USB Controller			[Enabled]
	USB 2.0 Controller			[Enabled]
	USB Keyboard Support			[Disabled]
	USB Mouse Support			[Disabled]
	Legacy USB storage detect			[Enabled]
	Azalia Codec			[Auto]
	Onboard H/W LAN			[Enabled]
`	SMART LAN			[Press Enter]
	Onboard LAN Boot ROM			[Disabled]
	Onboard Serial Port 1			[3F8/IRQ4]
	Onboard Serial Port 2			[2F8/IRQ3]
	Onboard Parallel Port			[378/IRQ7]
	Parallel Port Mode			[SPP]
x ECP Mode Use DMA				3
KLJI: Move		Enter: Select		+/-/PU/PD: Value	F10: Save	ESC: Exit	F1: General Help
	F5: Previous Values			F6: Fail-Safe Defaults		F7: Optimized Defaults
	On-Chip Primary PCI IDE
	Enabled		Enable onboard 1st channel IDE port. (Default value)
	Disabled		Disable onboard 1st channel IDE port.
	On-Chip SATA Mode
	Disabled		Disable this function.
	Auto		BIOS will auto detect. (Default value)
	Combined		Set On-Chip SATA mode to Combined, you can use up to 4 HDDs on
			the motherboard; 2 for SATA and the other for PATA.
	Enhanced		Set On-Chip SATA mode to Enhanced, the motherboard allows up to 6
			HDDs to use; 4 for SATA and the other for PATA.
	Non-Combined		Set On-Chip SATA mode to Non-Combined, SATA will be simulated to
			PATA mode. Support a maximum of 4 SATA devices. PATA devices will be
			ignored.
	PATA IDE Set to
	Ch.0 Master/Slave Set PATA IDE to Ch. 0 Master/Slave. (Default value)
	Ch.1 Master/Slave Set PATA IDE to Ch. 1 Master/Slave.
	SATA Port 0/2 Set to
	This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
	If PATA IDE were set to Ch. 1 Master/Slave, this function will auto set to Ch. 0 Master/Slave.
	SATA Port 1/3 Set to
	This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
	If PATA IDE were set to Ch. 0 Master/Slave, this function will auto set to Ch. 1 Master/Slave.
	USB Controller
	Enabled		Enable USB controller. (Default value)
	Disabled		Disable USB controller.

GA-945PLM-(D)S2 (rev. 2.1) Motherboard - 36 -