Gigabyte GA-73PVM-S2H user manual Drive a, Floppy 3 Mode Support, Halt on, Memory

Page 40

The following fields display your hard drive specifications. If you wish to enter the parameters manually, refer to the information on the hard drive.

Capacity

Approximate capacity of the currently installed hard drive.

Cylinder

Number of cylinders.

Head

Number of heads.

Precomp

Write precompensation cylinder.

Landing Zone

Landing zone.

Sector

Number of sectors.

Drive A

Allows you to selects the type of floppy disk drive installed in your system. If you do not install a floppy disk drive, set this item to None. Options are: None, 360K/5.25", 1.2M/5.25", 720K/3.5", 1.44M/3.5", 2.88M/3.5".

Floppy 3 Mode Support

Allows you to specify whether the installed floppy disk drive is 3-mode floppy disk drive, a Japanese standard floppy disk drive. Options are: Disabled (default), Drive A.

Halt on

Allows you to determine whether the system will stop for an error during the POST.

No Errors

The system boot will not stop for any error.

All Errors

Whenever the BIOS detects a non-fatal error the system boot will stop.

All, But Keyboard

The system boot will not stop for a keyboard error but stop for all other

 

errors. (Default)

All, But Diskette

The system boot will not stop for a floppy disk drive error but stop for all

 

other errors.

All, But Disk/Key

The system boot will not stop for a keyboard or a floppy disk drive error but

 

it will stop for all other errors.

Memory

These fields are read-only and are determined by the BIOS POST.

Base Memory Also called conventional memory. Typically, 640 KB will be reserved for the MS-DOS operating system.

Extended Memory The amount of extended memory.

GA-73PVM-S2H Motherboard

- 40 -

Image 40
Contents GA-73PVM-S2H Motherboard Copyright DisclaimerDocumentation Classifications Identifying Your Motherboard RevisionTable of Contents Regulatory Statements Box Contents GA-73PVM-S2H Motherboard Layout Block Diagram Hardware Installation Installation PrecautionsProduct Specifications CPU4 Mbit flash Page Installing the CPU and CPU Cooler Installing the CPUCPU Socket Lever Installing the CPU Cooler Installing the Memory Installing a MemoryInstalling an Expansion Card PCI Express x16 Graphics Card Support List Gigabyte GV-RX30HM128D Back Panel Connectors PS/2 Keyboard and PS/2 Mouse PortSub Port DVI-D PortOptical S/PDIF Out Connector USB PortIeee 1394a Port ESATA 3Gb/s PortMic In Jack Pink Dual Display ConfigurationsPlayback of HD DVD and Blu-ray Discs Internal Connectors IDE Coma SATAII0/1/2 LPT Pwrled Battery Clrcmos FpanelGND FDD Floppy Disk Drive Connector CPUFAN/SYSFAN Fan HeadersIDE IDE Connector SATAII0/1/2 Sata 3Gb/s ConnectorsPwrled System Power LED Header BatteryFpanel Front Panel Header Cdin CD In Connector Faudio Front Panel Audio HeaderSpdifio S/PDIF In/Out Header FUSB1/FUSB2/FUSB3 USB Headers, Yellow15 F11394 Ieee 1394a Header, Gray Coma Serial Port HeaderLPT Parallel Port Header CI Chassis Intrusion HeaderClrcmos Clearing Cmos Jumper GA-73PVM-S2H Motherboard Bios Setup Following screen may appear when the computer boots Startup ScreenBios Setup Program Function Keys Sample Bios Version F4aMain Menu „ Standard Cmos Features „ Advanced Bios Features„ Power Management Setup „ PnP/PCI ConfigurationsDate TimeIDE Channel 0 Master/Slave IDE Channel 2/3 Master/SlaveFloppy 3 Mode Support Drive aHalt on MemoryHard Disk Boot Priority First/Second/Third Boot DevicePassword Check HDD S.M.A.R.T. CapabilityLimit Cpuid Max. to 3 Note No-Execute Memory Protect NoteCPU Enhanced Halt C1E Note CPU Thermal Monitor 2 TM2 NoteIDE Prefetch Mode SATA-II RAID ConfigOn-Chip IDE Channel0 NV Serial-ATA ControllerOnchip Sata Mode Onboard LAN Boot ROMSATA-II Pri-Master RAID SATA-II Pri-Slave RAIDSmart LAN LAN Cable Diagnostic Function When No LAN Cable Is AttachedParallel Port Mode ECP Mode Use DMALegacy USB storage detect Onboard Serial PortModem Ring On PME Event Wake UpUSB Resume from Suspend Power-On by Alarm Power On By MousePower On By Keyboard KB Power on PasswordPCI 1 IRQ Assignment PnP/PCI ConfigurationsPCI 2 IRQ Assignment Reset Case Open Status Current System/CPU TemperatureCPU Warning Temperature Case OpenedCPU Smart FAN Control CPU Smart FAN ModeSystem Smart FAN Control FSB & Memory Config MB Intelligent TweakerM.I.TParameters/ Setting/ Current Value FSB-Memory Clock ModeCurrent CPU Freq, MHz FSB-Memory RatioLoad Fail-Safe Defaults Load Optimized DefaultsSet Supervisor/User Password Save & Exit Setup Exit Without SavingDrivers Installation Installing Chipset DriversSoftware Applications Driver CD InformationHardware Information Contact UsGA-73PVM-S2H Motherboard Before You Begin Xpress Recovery2System Requirements Installation and Configuration Installing Windows XP and Partitioning the Hard DrivePage Accessing Xpress Recovery2 Using the Backup Function in Xpress Recovery2Removing the Backup Using the Restore Function in Xpress Recovery2Exiting Xpress Recovery2 Bios Update Utilities Updating the Bios with the Q-Flash UtilityUpdating the Bios Page Installing and Using @BIOS Updating the Bios with the @BIOS UtilityOptions and Instructions Update the Bios without Using the Internet Update Function EasyTune EasyTune 5 Interface Button Information TableWindows Vista ReadyBoost Configuring Sata Hard Drives Configuring the Onboard Sata ControllerTo configure Sata hard drives, follow the steps below Installing Sata hard drives in your computerConfiguring Sata controller mode in Bios Setup RAIDConfiguring RAID set in RAID Bios AppendixYES BBS Required for Ahci and RAID Mode Making a Sata RAID/AHCI Driver DisketteInstalling the Sata RAID/AHCI Driver and Operating System Installing Windows XPSelect Nvidia nForce Storage Controller and press Enter Enter= Continue R=Repair F3=Exit Installing Windows Vista Note \Chipset\IDE\Vista\MCP7364\IDE\WinVista64\sataraidPage Configuring 2/4/5.1/7.1-Channel Audio Configuring Audio Input and OutputConfiguring Speakers Activating an AC97 Front Panel Audio Module Configuring Sound EffectMuting the Back Panel Audio For HD Audio Only Installing the S/PDIF In and Out Cable Optional Installing the S/PDIF In and Out CablePdif Pdif outConfiguring S/PDIF out Configuring Microphone Recording Appendix Recording the Sound Using the Sound RecorderPlaying the Sound Troubleshooting Frequently Asked QuestionsTroubleshooting Procedure StartEND Regulatory Notices Weee Symbol StatementOur Commitment to Preserving the Environment China Restriction of Hazardous Substances Table GA-73PVM-S2H Motherboard Appendix GA-73PVM-S2H Motherboard Contact Us B.T. INC USA MexicoGigabyte Global Service System