Cisco Systems 400 quick start Optional Install Switched Uplink Module Hub

Connect the Hub to Other Network Devices (continued)

			DC INPUTS FOR REMOTE
RATING		UP	POWER SUPPLY
			SPECIFIED IN MANUAL
100-127	/ 200-240 V~	CONSOLE	+5V @6A, +12V @1A
2A /1A	50 / 60 Hz		DC INPUT
			10/100 BASE-TX
		DOWN

			DC INPUTS FOR REMOTE	10/100 BASE-TX
RATING		UP	POWER SUPPLY
			SPECIFIED IN MANUAL
100-127	/ 200-240 V~	CONSOLE	+5V @6A, +12V @1A
2A /1A	50 / 60 Hz		DC INPUT
		DOWN

MEDIA MODULE

			DC INPUTS FOR REMOTE	100 BASE-FX
RATING		UP	POWER SUPPLY
			SPECIFIED IN MANUAL
100-127	/ 200-240 V~	CONSOLE	+5V @6A, +12V @1A
2A /1A	50 / 60 Hz		DC INPUT
		DOWN

MEDIA MODULE

3

(Optional) Install the

Switched Uplink Module in

the Hub

1Power off the hub.

2Remove and set aside the screws attaching the faceplate to expansion slot on the hub. The screws will be used later in Step 6.

3Remove the faceplate from the hub and store it for future use.

4Slide the module into the slot card-guides until you feel it touch the back of the hub.

5Push the module firmly until it snaps into place and is firmly seated.

6Insert and tighten the screws on the module faceplate.

7Power on the hub.

(Optional) Connect to the Switched Uplink Module Port

Insert a connector according to the type of module (10/100 or 100BaseFX), as follows:

•10BaseT/100BaseTX connector—Insert the connector until it snaps into place in the module port.

Note: Use a straight-through cable to connect two ports when one of the ports is designated with an X. Use a crossover cable to connect two ports when both ports are designated with an X.

•100BaseFX SC connector—Remove the rubber plugs from the fiber-optic port on the module and store them for future use. Insert the connector in the fiber-optic module port.