Optional Connect the Console Cable | Cisco Systems 400 manual

Connect the Hub to Other Network Devices (continued)

RATING
100-127	/ 200-240 V~
2A /1A	50 / 60 Hz

Power outlet

RJ-45-to-RJ-45 rollover console cable (supplied)

	DC INPUTS FOR REMOTE
UP	POWER SUPPLY
UP	SPECIFIED IN MANUAL
CONSOLE	+5V @6A, +12V @1A
	DC INPUT
DOWN

Console port

(RJ-45)

10/100 BASE-TX

STAT DUP 100

MEDIA MODULE

(Optional) Connect the Console Cable

1Make sure console port settings of the FastHub 400M model match the settings of the terminal, PC, or laptop. The default settings of the hub console port are 9600 baud, 8 data bits,

1 stop bit, no parity, and no flow control.

2Connect the rollover console cable to the CONSOLE port on the hub.

3Connect the other end of the rollover cable to your terminal, PC, or laptop (if necessary, use an appropriate adapter, such as the supplied RJ-45-to-DB-9 adapter).

4From your terminal, PC, or laptop, start the terminal emulation program.

RJ-45-to-DB-9

adapter (supplied)

Power Up the Hub

1Connect one end of the power cord to the hub and the other end to a power source.

Note: You can use the internal power supply and the Cisco 600W AC Redundant Power System (RPS). Attach only the Cisco RPS (model PWR600-AC-RPS) to the RPS receptacle.

2Wait approximately 2 minutes for the hub to complete its power-on self-test (POST).

After POST completes, the Continue with configuration dialog? prompt appears on the management station. You can then follow the prompts to assign IP information to the hub.