Setting up
Follow these steps to set up your Synergy 2150 ready for use.
Plan the location of your
Synergy 2150
1 Connect the power cable
Your Synergy 2150 works by sending and receiving radio signals between the base station and the handset.
The strength of the signal can depend on where you site the base station. Generally, the higher the base station is located the better. An upstairs room is ideal.
The following points should be considered:
•It should be within 3 metres of a power socket and phone socket otherwise extension cables will be required.
•Try to avoid locations near metallic obstructions or electrical appliances, such as TV sets, fridges, computers, fluorescent lights, radiators, metal pipes and metal window frames.
Please note
The Synergy 2150 has a range of up to 300 metres outdoors and up to 50 metres indoors. It is possible that the range may be affected by being near water (e.g. large ponds, lakes and the sea) as well as large metal objects (e.g. radiators, metal partition walls and steel girders).
Plug the power cable into the power socket on your Synergy base station.
Plug the adaptor into the mains power supply and switch on. The power light comes on and starts to flash. This will continue flashing until the Day & Time are set (see page 22).
Install the rechargeable
2battery in the handset
The Synergy 2150 uses a nickel metal hydride (NiMH) battery pack supplied. Take care to connect the battery as shown and replace the battery cover.
SETTING UP
10
