Chapter 3 Installing the Client Adapter
Inserting a Client Adapter
Follow the steps below to position the PCI card’s antenna on a flat horizontal surface or to mount it to a wall.
Step 1 Perform one of the following:
•If you want to use the antenna on a flat horizontal surface, position the antenna so it is pointing straight up. Then go to Step 7.
•If you want to mount the antenna to a wall, go to Step 2.
Step 2 Drill two holes in the wall that are 1.09 in. (2.8 cm) apart. Figure
Figure 3-5 Bottom of Antenna Base
1.09 inches
95597
Step 3 Tap the two supplied wall anchors into the holes.
Step 4 Drive the two supplied screws into the wall anchors, leaving a small gap between the screw head and the anchor.
Step 5 Position the mounting holes on the bottom of the antenna base over the screws (see Figure
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
|
| ||
|
|