Wiring Diagram

Auxiliary Video Display

Out-V (Yellow)	Out-R (Red)	Out-L (White)	Out-V (Yellow)	Out-R (Red)	Out-L (White)
eLni	Line	Line	ineL	Line	Line

AV1 Video

Dome Light

Source

Power source

12 Pin Power / Signal harness

*Antenna for Wireless FM Mod.

**See Antenna Note

* Optional Relay Box

SIRSWB

2 Pin Power

Wire Harness

with choke

Figure A

1)Make the connections to the vehicle for the 12 pin wiring harness.

2)Connect power harness to vehicles electrical system by tapping into an accessory hot line and a good ground.

3)Connect the 12 pin harness to the mating connector on the video monitor.

4)Verify all functions of the system before final mounting of the finished assembly. A/V Source Definitions:

1. PS2 - Built in song PS2

2.AV1 - Supplied 12 Pin Power / Signal Harness to 3 RCA Jack Pigtail is used for AV1 input.

3.AUX - AUX input.

*NOTE: If the optional relay box is P/N SIRSWB installed, it recommended that the antenna for the FM modulator antenna wire is unplugged. See VOD10PS2 Wiring Diagram (Figure A) for antenna location.

**NOTE: Extending the wireless antenna beyond its 12 inch length will cause the

FM modulator to exceed FCC limits of wireless transmission. When installing the unit position the antenna for best reception.