Audiovox ADV350B, ADV350S, ADV350P manual

ADV350

*ANTENNA FOR WIRELESS FM MOD ** See Antenna Note Below

*OPTIONAL RELAY BOX

SIRSWB

CHOKE

Power Harness

Item #3

To Secondary AV Monitor

12 VDC Power and Ground	INPUT	RCA-Female
	VIDEO			TO
Auxillary			LINE	OPTIONAL	Line Out-L (White)
			OUT	ADDITIONAL
		Patch Cord		MONITOR
video display			VIDEO
		RCA Male to Male			Line Out-R (Red)
			(Yellow)
					Line Out-V (Yellow)

UNIT (BACK VIEW)

TV

ANTENNA

PODTVT

To TV Antenna In

	Accessory	Power Harness
		Item #3
	Harness - Optional
Dome Light
	(P/N:8010730)
Power Source
	Red RCA (Audio Right)
	White RCA (Audio Left)
	Yellow RCA (Video)
		OPTIONAL
Power Connector	"Y" Adapter
4 Pin	for use with
Clean the IR Receiver Window on the front of the VCP.	Non-Stereo
Remove Adhesive Backing and Apply IR LED to IR	Installations

Item# 5

Figure A

1)Make the connections to the vehicle for the 12 pin wiring harness.

2)Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB.

3)Pull the wire tie loop tight and cut off the excess.

4)Connect the 12 pin harness to the mating connector on the Video Monitor.

5)Connect power harness to vehicle’s electrical system by tapping into an accessory hot line and a good ground.

6)Verify all functions of the System before final mounting of the finished assembly.

7)Mount and connect the Television antenna. (Optional)

Note: A VCP or other A/V Component can be connected to the video monitor system using a second

source component harness (purchased separately, part number: 8010730). This harness would plug into the Mini-Din connector on the main PCB as in steps 2 and 3 above.

A/V Source Definitions:

1= AV1, VCP or VCP with TV Tuner (Mini-Din on main PCB) 2= AUX-IN (VCP, Game or future DVD etc...)

3= Built-in DVD

4= TV (TV Tuner)

*NOTE: If the original relay box P/N SIRSWB is installed, it recommended that the antenna for the wireless FM Modulator be unplugged. See Figure A for antenna location.

**NOTE: Extending the wireless antenna beyond its 12 inch length will cause the FM Modulator to exceed FCC limits for wireless transmission. When installing the unit position the antenna for best reception.

-6-