Apple Drive Interconnect Board warranty

Page 2

4.If the server is in the locked position (the yellow security LED on the front panel is on), use the Allen key that came with the server to unlock it.

5.If the cable management arm is not in use, unplug all external cables except the power cord.

6.Touch the server’s metal case to discharge any static electricity.

Important: Always ground yourself by touching the server’s case before you touch any parts or install any components inside the server. To avoid static electricity building back up in your body, do not walk around the room until you have completed your work and closed the computer.

7.Unplug the power cord.

Warning: The power supply in the server is a high-voltage component and should not be opened for any reason, even when the server is off.

8.Release the two thumbscrews at the front of the server. (Figure 1)

Note: The thumbscrews are captive and do not separate from the bottom housing.

Figure 1

Xserve Drive Interconnect Board - 2

Image 2
Contents Tools Required Opening the ServerPage Removing the Installed Drive Interconnect Board Hard DrivesPage Blowers Heatsink Duct ATA Controller Board Drive Interconnect Board Installing the Replacement Drive Interconnect Board Page Closing the Server Apple Computer, Inc