Apple Drive Interconnect Board warranty Heatsink Duct

Page 6

Heatsink Duct

Note: There are two versions of Xserve. If your version does not include a plastic duct over the heatsink, skip to “ATA Controller Board” on the following page.

1.Release the latch on the heatsink duct from its slot, slide the duct away from the blower, and lift the end of the duct as shown. (Figure 6)

2.Remove the duct from the server.

Figure 6

Xserve Drive Interconnect Board - 6

Image 6

Contents Tools Required Opening the ServerPage Removing the Installed Drive Interconnect Board Hard DrivesPage Blowers Heatsink Duct ATA Controller Board Drive Interconnect Board Installing the Replacement Drive Interconnect Board Page Closing the Server Apple Computer, Inc