Step 4 Turn over the PCB and secure the hard drive to the PCB with the | Ruby Enclosure |
mounting screws that come with the kit. |
|
Step 5 Mount the board to the bottom cover.
Step 6 Put the top cover on by holding it in near vertical position and sliding the two metal clips inside the two small slots on the rear of the bottom cover.
Step 7 Lower the front of the top cover and making sure the two covers lined up properly. Tighten the small retaining screw on the front of the bottom cover to close the enclosure.
Switch Power LED and
Drive Access LED
Switch:
INT: This mode is used when the enclosure is placed inside a drive cradle. For mobile rack kits, this is the mode used.
EXT: This mode is used if the enclosure is used as an external hard drive.
Ruby Drive Cradle
Note: You can only use one power connector at a time. Either use the
power connector | data connector |
Mounting holes for 3 ½” drive bay