BenQ FP71G+ user manual Connect the power cable to the monitor

Page 7

3. Connect the power cable to the monitor.

Plug one end of the power cord into the socket labelled ’POWER IN’ on the rear of the monitor. Do not connect the other end to a power point just yet.

4. Route the cables via the loose bracket.

Release the cable retaining clip by squeezing the clip inwards as illustrated. Position the cables together and reinsert the clip over them to retain the cables neatly in place behind the monitor stand.

7How to install your monitor hardware

Image 7

Contents Welcome Copyright Table of Contents 111Getting started Front View Back View 1211Getting to know your monitorAttach the monitor base 1311How to install your monitor hardwareConnect the power cable to the monitor Connect-to and turn-on the power Prepare the monitor and area How to detach the stand base1411How to install your monitor’s software How to install your monitor’s software Choose Monitor from the list and then click Next Windows XP 1511Choosing the best picture resolution Choosing the best picture resolution 1611How to choose the right Refresh Rate How to choose the right Refresh Rate How to choose the right Refresh Rate 1711How to set the Picture Optimization Brightness and Contrast hot key 1811How to adjust your monitorHot Key Mode Look at the Control PanelMain Menu Mode Geometry sub menu Color sub menu OSD sub menu Languages Sub menu Recall sub menu Miscellaneous sub menu Frequently Asked Questions FAQ 1911TroubleshootingNeed More Help? 1011Supported operating modes Incoming display mode Input timingBenQ FP71G SpecificationsModel FP71G+ BenQ FP71G+