Philips EXP 200 manual IN-CAR Connection, In-car use connections supplied or optionally available

IN-CAR CONNECTION

English

In-car use (connections supplied or optionally available)

Only use the AY 3545 car
voltage converter (4.5 V, DC,	12 V DC
positive pole to the center
pin) and the AY 3501 car
cassette adapter. Any other
product may damage the set.
1 Put the CD player on a
horizontal, vibration-free and
stable surface. Make sure it	4,5 V DC
is a safe place, where the
player is not a danger or

obstacle to the driver and passengers.

2Insert the voltage converter into the cigarette lighter socket. If necessary, clean the cigarette lighter socket to obtain a good electrical contact. (only for a 12 V car battery, negative grounding).

3Connect the DC plug of the voltage converter to the 4.5V DC socket of the CD player.

4Turn down the volume and connect the cassette adapter plug to the LINE OUT / p of the CD player.

5Carefully insert the cassette adapter into the car radio’s cassette compartment.

6Make sure the cord does not hinder your driving.

7Start the CD player, set VOL E to position 8 and adjust the sound with the car radio controls.

•Always remove the voltage converter from the cigarette lighter socket when the CD player is not in use.

Notes: – Avoid excessive heat from the car heating or from direct sunlight (e.g. in a parked car in the summer).

–If your car radio has a LINE IN socket, use the LINE IN socket for the car radio connection instead of the cassette adapter. Connect the signal lead to this LINE IN socket and the LINE OUT / p socket of the CD player.

12