Philips CDR775/777 Manual recording from external CD player, Preparing for manual recording

Page 19

Manual recording from external CD player

 

 

 

 

 

 

 

 

 

EASY JOG

STORE/

CANCEL/

 

 

 

 

 

CD

 

 

 

 

 

MENU

DELETE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ENTER

 

 

OPEN // CLOSE

PLAY // PAUSE

STOP

REC

RECORD

FINALIZE

 

 

EXT

 

 

 

 

 

 

TYPE

ERASE

 

 

 

 

 

 

 

 

 

 

 

SOURCE

 

 

 

 

 

 

 

 

 

 

 

 

 

CDR

 

 

 

 

 

 

ANALOG

 

RW

 

 

 

 

 

 

 

 

 

 

 

 

CDR 77X

AUDIO CD RECORDER

 

 

 

 

 

 

PROG

SHUFFLE

DISPLAY

 

 

 

PHONES

 

 

 

 

 

SCROLL

REPEAT

DJ MODE

 

 

 

 

 

 

 

 

Important:

-Recording from CD-changers should always be started in the Auto-Start mode.

-Only make analog recordings when digital recording is not possible.

Preparing for manual recording

1 Make sure the disc is absolutely free of scratches and dust particles.

2 Press EXT(ernal) SOURCE repeatedly until (depending on the connection used):

➜DIGITAL I, OPTICAL I or ANALOG lights up and DIGITAL 1, OPTICAL or ANALOG appears on the display.

REM REC TIME TRACK

TOTAL REM TRACK TIME

STEP

SYNC MANUAL

RECORD

PROG

 

 

SHUFFLE ALL

•When Auto Track is On (default setting), track numbers will automatically be increased during recording.

•To switch off the Auto Track function you have to enter Menu mode.

If you wish to increase track numbers manually, press TRACK INCR(ement) on the remote control. For further instructions see Menu mode.

ON (Auto): The track increments are automatically taken over from the digital source material or after 2.7 seconds silence during analog recording.

OFF (Manual): While recording track numbers can be incremented manually by pressing TRACK INCR(ement) on the remote control. (Minimum track length is 4 sec.) (This can also be done in Auto track ON mode.)

• Track numbers cannot be changed after recording.

Note: Auto track works only with Consumer Sources with a digital output signal according to the IEC 958 (consumer part) audio standard.

3 With the recorder stopped, press REC TYPE five times to

enter the Manual Record standby mode.

RECORDING

➜MANUAL starts to flash and the display shows REC EXT MAN followed by WAIT. After a few seconds PRESS RECORD followed by the remaining time and track number appear on the display.

REM REC TIME TRACK

TOTAL REM TRACK TIME

STEP

SYNC MANUAL

RECORD

PROG

 

 

SHUFFLE ALL

4 Play the source first to set the optimal recording level on the CD recorder.

5 Rotate the EASY JOG/ENTER key until, on the Record/Play Level bar, all the blue segments are alight, but the red segments do not light continuously during the loudest passages.

➜Display shows _XX DB (Decibel, e.g. -3DB).

6 Stop the source.

Start manual recording

1 To start recording, press RECORD on the CD recorder and

immediately start the source (from Pause or Stop-mode).

➜d lights continuously. The track number and recording time left appear on the display.

•If CHECK INPUT message also flashes, the digital connection is incorrect.

•To record a 3-second silence at the start of a track, press PAUSE on the CD recorder before starting the source.

•To check the total remaining recording time, press DISPLAY on the CD recorder. (This can also be done during the recording.)

2 To stop recording, press STOP on the CD recorder.

➜ UPDATE lights up and d goes out.

•If STOP was pressed within 3 seconds after RECORD, no recording will take place.

•To interrupt recording, press PAUSE on the CD recorder. d starts to flash. Press PAUSE again to restart recording. ( A new track will always be made.)

After recording the display will show UPDATE for several seconds.

Note: With AUTO TRACK ON, the recorder will stop and go to REC STANDBY for 1 minute and then goes to Stop mode automatically. Recordings from DAT, DCC or recordings made analogously will stop after 20 seconds silence. With AUTO TRACK OFF, the auto stop mode is disabled.

Important:

If you want to play the recorded CDR disc on any regular CD player, it must first be finalized. See finalizing discs.

Finalized CDRW discs play only on CDRW compatible CD players.

For recording from CD changers always use REC EXT 19

English

Page 18 Page 20
Image 19
Page 18 Page 20
Contents CDR775/777 For Customer Use General InformationVarning VaroitusContents English Table of Contents Audio Technical dataAbout this manual GeneralDiscs for playback Discs for recording Maintenance EnglishAccessories General Information and DiscsCD recorder Controls and ConnectionsControls on the front EnglishConnections at the back Controls and Connections DisplayDisplay indications Display messages Menu messages See Menu mode Display InstallationConnections general An external analog source This connection must be made for playback on the CDRecorder deck as well as the CD player deck cable Will be the case in DJ-modeOutput This connection is only required if you want to makeUse the digital coaxial cable supplied Setup recommendations Power supply Inserting batteries in the remote controlPress ON/OFF CD recorder will switch on Track INCRement Remote ControlRemote control commands Inserting discs English Number/alphabet keys 0Remarks about recording RecordingRecording modes Start high speed recording Preparing for high speed recordingTo start recording, press Record Listen mode recording from internal CD playerPreparing for Listen mode recording Start Listen mode recordingTrack numbers cannot be changed after recording Enter the Manual Record standby modeManual recording from external CD player Preparing for manual recordingIf you wish to record a complete disc or program Preparing for autostart recordingStart autostart recording For Cdrw discs only Finalizing CDR & Cdrw discs Unfinalizing Cdrw discs EnglishAuto finalizing Manual finalizingTo erase one or more tracks from the end Erasing Cdrw discsTo erase the entire disc Playing Play a 2-disc changer Changer modeSearch Selecting a track when CD play is stoppedHold down 5 or 6 in play mode Selecting a trackPress Repeat one or more times during CD play Only in Changer modeShuffle random order play Repeat CD, track or programClearing a program ProgrammingRemarks about programming Programming for playbackRemarks about Menu mode General operation of Menu English Menu ModeMaximum of 60 characters can be stored per item Menu MODE/CD TextEnglish Text input/text edit Erasing text/text eraseReviewing CD Text in memory/memory view Balance only active in Record/Standby mode Menu MODE/RECORDING SettingsEnglish Auto track increment/auto track Fixing Problems 3104 125

CDR775/777 specifications

The Philips CDR775/777 is a pioneering product in the realm of digital audio, specifically designed for users who appreciate the ability to record audio directly onto CD. Introduced in the late 1990s, this device stands out not only for its recording capabilities but also for its robust set of features that cater to audio enthusiasts.

One of the primary features of the CDR775/777 is its dual function as both a CD player and a CD recorder. It allows users to effortlessly play their favorite CDs while also providing the ability to create audio CDs from various sources. This is particularly convenient for individuals looking to create their own compilations or preserve favorite vinyl records and cassette tapes in digital format.

The device uses a sophisticated digital-to-analog converter (DAC) that ensures high-fidelity sound reproduction. The inclusion of technologies like Pulse Width Modulation (PWM) enhances audio clarity and reduces distortion, providing a rich listening experience. The CDR775/777 supports both CD-R and CD-RW media, enabling users to choose between permanent and rewritable audio formats.

Another notable characteristic is its user-friendly interface. The front panel features an easy-to-read display and straightforward controls, making navigation simple for users of all experience levels. It allows for the easy selection of tracks, programming of playlists, and even offers features like track naming for more personalized recordings.

The CDR775/777 also includes advanced features such as automatic track incrementing, which detects silence between tracks and automatically separates them as individual tracks on the recorded CD. This is particularly beneficial for live recordings where the artist may pause between songs. Additionally, the ability to connect to external audio sources through standard RCA inputs broadens the versatility of this device, allowing for recordings from a variety of devices.

In terms of build quality, the CDR775/777 is constructed with durability in mind, featuring a solid chassis that helps reduce vibration and interference during playback and recording. The emphasis on quality extends to its playback capabilities, supporting a wide range of audio formats.

In essence, the Philips CDR775/777 is more than a simple CD recorder; it is a versatile tool for any audio lover. Combining high-quality audio performance with user-friendly features and robust recording capabilities, it represents an important innovation in home audio technology. Whether for archiving personal music collections or creating custom mixes, the CDR775/777 continues to be a valued asset in any audio setup.
Top Page Image Contents