Quick Installation, On Switch | Tripp Lite TE-300, TE-700L specs

Quick Installation

1 Plug your UPS into an electrical outlet.

2 Plug your computer, monitor and external modem into battery- supported outlets. Plug other equipment into surge-only outlets.*

3	Set your UPS’s “OFF –
	ON” Switch.**

USA, Canada & Western Europe

· Set it and leave it “ON” at all times.

All Other Countries

·Set to “OFF” when you are not using connected equipment.

(WARNING! When set to "OFF," UPS will not provide battery backup during a blackout or brownout)

·Set to “ON” when you are using connected equipment.

*Separate battery-supported/surge and surge-only outlets are available only on select models (identified on the back of your UPS). Your UPS is designed to support only computer equipment. You will overload your UPS if you connect household appliances, laser printers or surge suppressors. ** See Basic Operation section for the Switch Function, UPS Conditions and Setting Advantages.

–Optional Installation–

OPTION 1

(select models)*

OPTION 1 (UPS Software)

Using Tripp Lite Cable (if supplied) connect the DB9 port of your UPS to the DB9 port of your computer. Load software (if supplied) and run the installation program appropri- ate for your operating system.

	OPTION 2 (Brownout Voltage Adjustment)
	Adjust the Voltage Potentiometer (UPS
	back panel) clockwise to lower the voltage	OPTION 2
	point at which the UPS switches from on-
	line to battery output.**
	* Your UPS will function properly without these
	connections or settings. ** For users who
	experience frequent, severe brownouts to avoid
	excessive battery drain. Note: Use caution when
	adjusting the potentiometer while the UPS is	NORM
	powering a voltage-sensitive load.	NORM
	powering a voltage-sensitive load.