Mounting
WARNING! Mount your Inverter BEFORE DC battery and AC power connection. Failure to follow these instructions may lead to personal injury and/or damage to the Inverter and connected systems.
Tripp Lite recommends permanent mounting of your Inverter. User must supply mounting hardware and is responsible for determining if the hardware and mounting surface are suitable to support the weight of the Inverter. Contact Tripp Lite if you require further assistance in mounting your Inverter.
Vehicular and Non-Vehicular Mounting
• Horizontal Mount • Vertical Mount
Whether mounted horizontally or vertically, the Inverter must be located in an enclosed compartment, shielded from outside weather conditions.
750 & 1250 models only
AUsing the measurements from the
diagram, install two user-supplied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving the heads slightly raised.
BSlide the Inverter back over the fasteners to engage the mounting slots molded on the bottom of the Inverter cabinet. C Install and tighten two user-supplied ¼" (6 mm) fasteners into the mounting feet molded on the front of the Inverter cabinet. The polycarbonate cabinet and mounting feet of your Utility/Work Truck Inverter are durable enough to allow for vertical mounting as well, if your vehicle compartment requires this configuration. For vertical mounting, the control panel of the Inverter should face up.
C
A
B
2012 model only
AUsing the measurements from the diagram, install two user-supplied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving the heads slightly raised. B Slide the Inverter forward over the fasteners to engage the mounting feet molded on the front of the Inverter cabinet. Install and tighten additional user-supplied ¼" (6 mm) fasteners into the mounting feet molded on the rear and sides of the Inverter cabinet. The rear feet extend beyond the unit’s cabinet to provide for adequate ventilation space behind the cooling fan(s); they should not be removed. The polycarbonate cabinet and mounting feet of your Utility/Work Truck Inverter are durable enough to allow for vertical mounting as well, if your vehicle compartment requires this configuration. For vertical mounting, the control panel of the Inverter should face up.
| 5.57 in. |
| (14.16 cm.) |
| 9.59 in. |
| (24.35 cm.) |
| B |
9.59 in. | 5.87 in. |
(24.35 cm.) | (14.91 cm.) |
5.57 in. | 5.87 in. |
(14.16 cm.) | (14.91 cm.) |
| 1.64 in. |
A | (4.15 cm.) |
|
3012 model only
AUsing the measurements from the diagram, install four user-supplied 1/4" (6 mm) fasteners into a rigid horizontal surface, leaving the heads slightly raised. B Slide the Inverter's keyhole mounting slots down over the raised fastener heads. Slide Inverter forward or backward to engage the slots and tighten fasteners. C For additional stability, install additional fasteners through the additional mounting slots provided on the Inverter.
C
C
| | A | |
12 in. | | | |
30.48 cm. | | | |
| B | 10.375 in. | |
4 in. | 26.35 cm. | 4 in. |
10.16 cm. | | | 10.16 cm. |
10.375 in.
26.35 cm.
12 in.
30.48 cm.
A
