Optional Installation, Basic Operation | Tripp Lite SMARTINT2200VS

Optional Installation

EPO Port Connection

This optional feature is only for those applica- tions which require connection to a facility’s Emergency Power Off (EPO) circuit. When the UPS is connected to this circuit, it enables emer- gency shutdown of the UPS's inverter.

Using the cable provided, connect the EPO port of your UPS (see 4a ) to a user-supplied normally closed or normally open switch according to the circuit diagram (see 4b ). The EPO port is not a phone line surge suppressor; do not connect a phone line to this port.

4a
OPTION 1: USER SUPPLIED NORMALLY CLOSED SWITCH
	5	4-5 JUMPER
RJ11	4	N.C. EPO SWITCH
RJ11	3
PLUG
PLUG
	2
	NO CONNECTION
OPTION 2: USER SUPPLIED NORMALLY OPEN SWITCH
	5	N.O. EPO SWITCH
RJ11	4
RJ11	3
PLUG	3	NO CONNECTION
4b	2	NO CONNECTION
4b

Basic Operation

Buttons

“ON/OFF/STANDBY” Button

•To turn the UPS ON: with the UPS plugged into a live AC wall outlet,* press and hold the ON/OFF/STANDBY button for one second.** Release the button. If utility power is absent, you can “cold-start” the UPS (i.e.: turn it ON and supply power for a limited time from its batteries***) by pressing and holding the ON/OFF/STANDBYbutton for one second.**

•To turn the UPS OFF: with the UPS ON and receiving utility power, press and hold the ON/OFF/STANDBY button for one sec- ond.** Then unplug the UPS from the wall outlet. The UPS will be completely OFF.

*After you plug the UPS into a live AC outlet, the UPS (in “Standby” mode) will auto- matically charge its batteries, but will not supply power to its outlets until it is turned ON. ** The alarm will beep once briefly after the indicated interval has passed. *** If fully charged.