Tripp Lite SMART750XLA warranty Surge / Noise Suppression, Physical, Environmental, Communications

Front panel LEDs

Alarms

Switches

Includes front panel LEDs to indicate line / battery power status, over / under voltage correction, battery charge level, load percentage, overload, wiring fault and replace battery.

Audible alarm warns of power failure condition

Includes two pushbutton switches for on/off power control and self-test/ alarm cancel functions. Also includes two dipswitch controls for setting the nominal voltage

SURGE / NOISE SUPPRESSION

AC surge	570 joules
suppression
AC suppression	Instantaneous
response time
Dataline suppression	Includes 8-wire RJ45 jack; pins 1, 2, 3 and 6 provide 10baseT Ethernet line surge suppression with 7.5V clamping; pins
	4 and 5 provide single-line tel/DSL line surge suppression starting at 260V
EMI / RFI AC noise	Yes
suppression
PHYSICAL
Shipping weight (lbs)	37
Shipping weight (kg)	16.8
Shipping Dimensions	13 x 10 x 23.75
(HWD/in)
Shipping Dimensions	33 x 25.4 x 60.3
(HWD/cm)
Unit weight (lbs)	33.9
Unit weight (kg)	15.4
Unit Dimensions	10.1 x 6.7 x 13.8
(HWD/in)
Unit Dimensions	25.7 x 16.9 x 35.1
(HWD/cm)
Material of	Steel
construction
Form factors	Tower
supported
Cooling method	Fan
Battery Access	Supports battery access and hot-swap replacement without powering connected equipment off
ENVIRONMENTAL
Relative Humidity	0 to 95%, non-condensing
COMMUNICATIONS
Network monitoring	Includes 2 built-in monitoring ports, 1 USB and 1 DB9. Each supports on battery, low battery, power restored, AC line
port	voltage, DC battery voltage, load percentage, battery charge current, battery capacity and line frequency status
	messaging.
Software and cabling	Includes PowerAlert UPS monitoring software for all common network and stand-alone operating systems. Ships with 2
included	cables, 1 USB and 1 DB9
SNMP compatibility	SNMP adapter accessory # SNMPWEBCARD
WatchDog	Compatible with Tripp Lite's WatchDog Software to restore operation to locked equipment through soft reboot of
compatibility	application/OS or hard power off/on reboot of connected equipment; ideal for unattended kiosk applications

LINE / BATTERY TRANSFER

Transfer time from line power to battery mode

4 milliseconds (typical)

Low voltage transfer to battery power

Switches to battery power as line voltage decreases to 95V (120V), 87V (110V) , or 83V (100V) or less. Resets back to line power mode as line voltage increases to 100V (120V), 92V (110V), or 87V (100V) or higher