Battery, Leds Alarms & Switches, Physical

Input connection type

Input cord length

Recommended Electrical Service

Maximum input amps / watts

BATTERY

DC INPUT: 175A Anderson DC connector. AC INPUT: NEMA 5-15P hospital-grade input plug

DC INPUT: 175A Anderson DC connector at the end of a 1 ft. 1/0 gauge color coded red/black cable. User supplies DC

input cabling for use with Anderson connector. AC INPUT: attached 3 ft. AC line cord with hospital-grade plug

DC INPUT: Requires 12VDC input source capable of delivering 127A for the required duration (when used at full continuous capacity - DC requirements increase during Over-Power and Double-Boost operation). For automotive applications, professional hardwire

DC INPUT: Full continuous load - 127A at 12VDC. AC INPUT: 32 amps at 120VAC with full inverter and charger load (11 A max charger-only / combined input load to support charger and AC output is automatically controllable to 66%-33%-0% based on AC output lo

Expandable battery runtime

DC system voltage

Battery recharge rate

Runtime is expandable with any number of user supplied wet or gel type batteries

12V

14A/55A (selectable)

LEDS ALARMS & SWITCHES

Front panel LEDs

Switches

Set of 6 LEDs offer continuous status information on load percentage (6 levels reported) and battery charge level (7 levels reported). See manual for sequences.

3 position on/off/remote switch enables simple on/off power control plus "auto/remote" setting that enables distant on/off control of the inverter system when used in conjunction with included External switch for wired remote control of APS unit APSRM4 ac

SURGE / NOISE SUPPRESSION

AC surge	760 joules AC surge suppression included
suppression

PHYSICAL
Shipping weight (lbs)	24.8

Shipping weight (kg)	11.2

Shipping	12.5 x 11 x 10.75
Dimensions (HWD/in)

Shipping	31.8 x 27.9 x 27.3
Dimensions
(HWD/cm)

Unit weight (lbs)	23.2

Unit weight (kg)	10.5

Unit Dimensions	7 x 8.75 x 9
(HWD/in)

Unit Dimensions	17.8 x 22.2 x 22.9
(HWD/cm)

Material of	Polycarbonate
construction

Form factors	Mounting slots enable permanent placement of inverter on any horizontal surface (see manual for additional mounting
supported	information)

Cooling method	Multi-speed fan

Style	Heavy-duty with built-in battery charger

ENVIRONMENTAL
Relative Humidity	0-95% non-condensing

LINE / BATTERY TRANSFER

Transfer time from line power to battery mode

Low voltage transfer to battery power

16.6milliseconds (typical - compatible with many computers - verify transfer time compatibility of loads for UPS applications)

In AC "auto" mode, inverter/charger switches to battery mode as line voltage drops to 75V (user adjustable to 85, 95, 105V - see manual)