Quick Installation

1 Position your External Battery Pack(s).

•If positioning multiple Battery Packs, place them side by side or stack them no more than three high.

2 Position your Power Module.

•The Module may be stacked on top of your Battery Packs or placed beside them.

3 Plug your External Battery Pack into your Power Module's External Battery Connector on its back panel.

•For multiple Battery Packs, connect the first to the Power Module, then daisy-chain the others: connect the second to the first, the third to the second, and so on.

	BRANCH CIRCUIT #1
	230VAC 10AMPS
00VA 4500W
M 50/60HZ 5000VA 3700W	CAUTION: DO NOT UNPLUG WHILE
50HZ 5000VA 3700W	OPERATING OR ARCING WILL OCCUR
	36VDC 175 AMPS MAX

4 Plug your Power Module into a

L6-30 single-phase AC outlet on a 30-amp dedicated circuit that provides 220V to 240V at 50 Hz.

5	Plug your equipment into the
	Power Module.
6	Turn your UPS ON.
6	• Set the System Switch on the UPS's back panel to the	230VAC 10AMPS
		BRANCH CIRCUIT #1
	“ENABLE” (RIGHT) position. (Figure 1a)
	This switch activates the battery charger and microprocessor.
	The “ ” light will flash until you engage the ON/Standby	30VAC NOM 50/60HZ 5000VA 3700W
		50/60HZ 5000VA 4500W
	Switch to activate the “ON” mode.	0VAC NOM 50HZ 5000VA 3700W
	Switch to activate the “ON” mode.	1a.
	• Engage the momentary ON/Standby Switch on the UPS's	Back panel
	• Engage the momentary ON/Standby Switch on the UPS's
	front panel and release it to activate the “ON” mode and
	supply power to the UPS receptacles. (Figure 2b)
		2b.
		Front panel

Tripp Lite Datacenter INT Quick Installation, Communications on Next, Position your Power Module