Standard Installation, Source a | Tripp Lite B119-2X2, B119-4X4

Standard Installation

Note:

1.The diagram below shows a B119-2X2 installation, but installation will be the same for the B119-4X4, except for the number of ports.

2.The back panel of the B119-4X4 contains an IR port which has been capped off. This port is intended for future use, and does not currently function.

B119-2x2

(Optional)

Blu-Ray™Up to 16 ft.

Up to 16 ft.

Up to 25 ft.

1Make sure all devices being connected are turned off.

2Optional: Connect the 3.5 mm to DB9 adapter to the RS-232 serial port on the switch, and then to the DB9 serial port on the computer you will be using to control it with.

3Connect the first HDMI source to the port on the switch marked

Source A.

Note: The HDMI cable connecting the source to the switch must be no longer than 16 ft.

4Repeat step 3 to connect additional HDMI sources to the remaining ports.

5Connect the external power supply to the switch and plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU), or Uninterruptible Power Supply (UPS). When receiving power, the following LEDs will illuminate: The Green Power LED and Orange

Source LEDs (for the Source ports that have devices connected to them). A Green LED will also illuminate to indicate the source that is being transmitted to each Output port.

13-08-038-9332BC.indd 4

8/5/2013 12:26:37 PM