Philips MX3910D/37 owner manual Getting Started, Inserting batteries into the remote control

Getting Started

E n g l i s h

Step 1: Inserting batteries into the remote control

3

1

2

1Open the battery compartment.

2Insert two batteries type R06 or AA, following the indications (+-) inside the compartment.

3Close the cover.

Using the remote control to operate the system

Step 2: Setting the clock

The clock can be set in either 12-hour or 24-hour mode ("12:00 AM" or "00:00" for example).

buttons on	DVD system’s
front panel	display panel
CLOCK•TIMER
2	SELECT CLOCK OR
CLOCK•TIMER
3	CLOCK
SEARCH
4	01:38 PM

PROG

513:38

CLOCK•TIMER

613:38

1Press STANDBY ON to switch on the DVD system.

2 Press and hold CLOCK•TIMER until

1Aim the remote control directly at the remote sensor (iR) on the front panel.

2Select the source you wish to control by pressing one of the source select buttons on the remote control (for example TV/AV,TUNER.)

3Then select the desired function (for example ÉÅ, S, T).

OPEN•CLOSE

DISC 1 DISC 2 DISC 3

DISC 1

DISC 2

DISC 3

DISC 4

DISC 5

iR SENSOR

DISC/

TV/AV MEDIA TUNER AUX/DI

1 2 3

4 5 6

7 8 9

SURR.	0	SOUND
	VOL
SYSTEM MENU		DISC MENU
SEATING		ZOOM
PREV		NEXT

OK

"SELECT CLOCK OR TIMER" appears.

3Press T (if necessary) to change the display to "CLOCK", then press CLOCK•TIMER again to confirm.

4Press S / T to set the minutes and hours.

To increase the speed, hold down Sor T.

➜ The changes in minutes will roll over to the hours.

5Press PROG to change between 12-hour and 24-hour clock mode.

STOPPLAY/PAUSE

DISC SKIP REPEAT REPEAT PROGRAM

CAUTION!

–Remove batteries if they are exhausted or if the remote is not to be used for a long time.

–Do not use old and new or different types of batteries in combination.

–Batteries contain chemical substances, so they should be disposed of properly.

6Press CLOCK•TIMER again to store the setting.

➜ The clock will start working.

To view the clock time in any active mode

●Press CLOCK•TIMER.

➜ The clock will display for a few seconds.

Helpful Hints:

–If the DVD system is disconnected from the power supply, it will erase the clock setting.

–If you do not press any buttons within 90 seconds, the system will exit clock setting mode.

18