AP Operation
Filtering (continued)
IP Filtering
To add an IP Filter:
1.Check the IP Filter Enable check box
2.Click Add. A dialog box similar to the one below appears:
3.Type the IP address (or the first IP address in a range of IP addresses) you wish to filter in the dialog box and click OK. A second dialog box, similar to the one below, appears:
MAC Filtering
To add a MAC Filter:
1. Click Add. A dialog box similar to the one below appears:
2.Type in the desired MAC address and click OK.
3.Repeat these steps for any additional MAC addresses you want to filter.
4.To filter a single IP address, key in the same address as the start IP. To filter a range of addresses, key in the last IP address in the range you wish to filter.
5.After filling in the address, click OK.
6.Repeat these steps for any additional IP addresses you want to filter.
To delete an IP Filter:
Select the desired IP Filter from the list and click Remove.
To modify an IP Filter:
1.Select the desired IP Filter from the list and click Edit. An Edit dialog box similar to the Add dialog box will appear.
2.Delete the old start IP address and replace it with the new one. Click OK.
3.Delete the old end IP address and replace it with the new one. Click OK.
Note: To block a computer from accessing the
To delete a MAC Filter:
Select the desired MAC Filter from the list and click Remove.
To modify a MAC Filter:
•Select the desired MAC Filter from the list and click Edit. An Edit dialog box similar to the Add dialog box appears.
•Delete the old address and replace it with the new one. Click OK.
Note: To block a computer from accessing the
50