Moxa Technologies EIP3000 DF1 user manual SW 2 SW

Page 21

MGate EIP3000 Series User’s Manual

Hardware: EIP3270, EIP3270I

Jumpers

SW 2 SW 1

The DIP switches are located beneath the DIP switch panel on the side of the unit.

To add a 120 Ω termination resistor, set switch 3 on the port’s assigned DIP switch to ON; set switch 3 to OFF (the default setting) to disable the termination resistor.

To set the pull high/low resistors to 150 KΩ, set switches 1 and 2 on the port’s assigned DIP switch to OFF. This is the default setting.

To set the pull high/low resistors to 1 KΩ, set switches 1 and 2 on the port’s assigned DIP switch to ON.

Switch 4 on the port’s assigned DIP switch is reserved.

ATTENTION

Do not use the 1 KΩ pull high/low setting on the MGate EIP3000 when using the RS-232 interface. Doing so will degrade the RS-232 signals and reduce the effective communication distance.

4-4

Image 21
Contents MGateTM EIP3000 DF1 to EtherNet/IP Gateway User’s Manual Trademarks MGate EIP3000 DF1 to EtherNet/IP Gateway User’s ManualTable of Contents Chapter Pin Assignments Introduction ‰ Overview ‰ Package Checklist ‰ Product FeaturesStandard Accessories Package ChecklistOptional Accessories OverviewProduct Features Getting Started Connecting Power Connecting Serial DevicesConnecting to a Host or the Network Mounting the Unit Installing the SoftwareHardware EIP3170, EIP3170I ‰ DIN-Rail, Wall Mounting ‰ SpecificationsName Color Function Panel Layout LED IndicatorsDimensions Jumpers DB9 Male Pin AssignmentsTerminal Block RS-422 Pin RS-232DIN-Rail, Wall Mounting Power Input, Relay OutputSpecifications Hardware EIP3270, EIP3270I Panel Layout LED Indicators 29 mm 1.14 SW 2 SW Pin RS-232 RS-422 DIN-Rail, Wall Mounting MGate EIP3000 Series User’s ManualHardware EIP3270, EIP3270I ‰ Installing the Software ‰ Starting MGate Manager Configuring the EtherNet/IP Gateway‰ Connecting to the Unit ‰ Modifying the ConfigurationMGMSetupVersionBuildDateTime.exe Page Page Page Starting MGate Manager Change Language SettingBroadcast Search Connecting to the UnitSpecify by IP Address Modifying the Configuration Parameter Value Configure IP Address and Other Network SettingsYou can set a password to prevent Configure Serial Communication Parameters How to set Routing on the MGate EIP3000 Set up Routing and ProCOM functionWhat is ProCOM? Set up Protocol Set Up Miscellaneous Monitoring EtherNet/IP Activity Verifying Location of UnitOpen Traffic Monitor Window Filter Description Filter Traffic InformationSave Log to File Upgrading FirmwarePage Pin Assignments DB9 Male RS-232 and RS-422 PinEIP3170, EIP3170I Pin Power Input, Relay Output Terminal Block RS-422Pin RS-422