Atlas Sound specifications PA601 Commercial Amplifier Rear Panel Description

PA601 COMMERCIAL AMPLIFIER

REAR PANEL DESCRIPTION

OWNER'S MANUAL

120V/230V-240V

FUSE

0.8A/250V FOR 230V~240V 1.5A/250V FOR 120V

F7,&'

7jbWiIekdZ7 fb_\_[h

Speaker Output 60W					Line In
						Balanced
COM	4	70V	100V			Line Input
				Unbalanced
				On
				Off	Line Out
CLASS 2 WIRING				Loudness		G	–	+
	£Èä£Ê>VŽÊV>ÞÊ Û`°]ʘ˜ˆÃ]Ê/8ÊÇx££™Ê
	­nää®ÊnÇȇÎÎÎÎÊ Ì>Ã-œÕ˜`°Vœ“

11 10 9 8 7 6

6.Balanced Input

Balanced line level signals connect to the (+), (–), and (G) terminals. Note if you are connecting an unbalanced line level input, tie (short) the (G) and (–) terminals together with an insulated jumper wire.

7.Line In

The Line In connector is useful for receiving a -6dBV mono unbalanced line level signal from a playback system such as a CD player.

8.Line Out

Line Out connector is useful for providing unbalanced line level signal to another amplifier or other external device.

9.Loudness Contour EQ

This switch, when in the ON position, provides +4dB of boost at 100Hz and 8kHz. Use of this EQ is suggested to enhance music playback at low levels.

10.Output Terminal Strip

For loudspeaker connections, connect as follows or proceed to the setup section for typical wiring schemes.

COM - Speaker common or negative connection 4Ω - Connect to direct coupled loudspeakers

70V - Connect to transformer coupled, 70.7V loudspeakers with a total load impedance of 83Ω 100V - Connect to transformer coupled, 100V loudspeakers with a total load impedance of 167Ω

11.IEC AC Receptacle

Prior to connecting a grounded power cord the proper selection of the AC Line switch and fuse must be made. For 120VAC use the 1.6A/250V fuse and for 230~240VAC use the 1A250V fuse.

Specifications are subject to change without notice

AtlasSound.com

1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. •			TELEPHONE: (800) 876-3333 •	FAX: (800) 765-3435
©2006 ATLAS SOUND LP	Printed in U.S.A.	00106	ATS002264 RevA 01/06	PP
				7