Instruction Manual
Installing the KVM Switcher Software
Please note: The Switcher Software provides an alternative way to operate KVM functions in addition to the original hardware hotkeys. If you are satisfied with the hardware hotkeys, software installation is not necessary.
Also note: The Windows switcher software is recommended for systems using Windows 98SE or later. The Mac switcher Software is recommended for use on Mac OS
10.4(Tiger) and later.
1.Insert the software CD (included) into the
2.Click on “Software Installation for Windows” to begin installation. Follow the instructions to completion. Once installation is finished, you will see a KVM Switcher icon appear on the system tray of your desktop.
the Mac switcher software (with a file extension of .pkg or .zip) and install it on your Mac.
Operation
There are three methods to control the KVM Switch for PC, USB hub and audio/mic channel selection: using the
Front Panel Buttons
The Front Panel buttons allow direct control over KVM switch operation and channel switching. Simply press the PC button for PC port switching. If binding is enabled between PC / USB hub port control / Audio and Mic switching, they will be jointly selected at the same time). If you wish to enable the binding of PC / Hub Port control / Audio and Mic switching, use the hotkey sequences described on page 7 .
Keyboard Hotkeys
A keyboard hotkey sequence consists of at least three specific keystrokes:
Hotkey sequence = [ScrLk]* + [ScrLk] * + Command key(s)
(*
To configure the KVM Switch to use a preceding sequence other than two consecutive Scroll Locks:
(1)Hit ScrollLock + ScrollLock + H, which will be followed by two beeps indicating readiness for selection of a new preceding sequence, or press and hold down the last
(2)Select and press the key you would like to use as your preceding sequence (SCROLL
3