Initial Power-Up

For SUN computers using a 13W3 connector for monitor connection, a 13W3-to-HDB15adapter is required for such computer’s monitor port as shown in figure 6.

Figure 6: Adapter and monitor connection

Make sure all computers and StarViews are powered down during installation. You must power up the Master StarView before turning on any other devices.

For single StarView configuration:

1)Apply a power adapter to the Master.

2)Turn on computers.

For cascade StarView configuration:

1)Apply a power adapter to the Master.

2)Apply power adapters to all Slaves.

3)Turn on computers.

Note: You may hot plug additional powered-down computer and Slave without turning any existing StarView or computer off after initial power up.