Step 6. Install the SANsurfer Router Manager
Management Console - System Requirements:
The SANbox 6142 Router comes with QLogic’s SANsurfer Router Manager application. (The Router management console can be a Windows, Solaris, Linux or MAC
The SANsurfer Router Manager application includes the Configuration Wizard, which
1.Insert the QLogic CD into the
2.A list of supported platforms will be displayed. Locate the appropriate platform and click Install.
3.If the product introduction screen does not display, open the QLogic CD with Windows Explorer and run the installation program, located in the following path:
For other OS Platforms please install appropriate packages. The CD subdirectory names identify the OS.
Step 7. Configure SANbox 6142 Management Port IP Address
Connect the router’s 10/100 Ethernet port to your workstation using a switch or hub. Alternatively you may connect your workstation directly to the router using an Ethernet crossover cable.
The SANbox 6142 management port’s default IP address is 10.0.0.1 subnet 255.0.0.0. Please make sure the workstation connected to the SANbox Router has Ethernet address 10.0.0.x, where x is other than 1 and subnet mask is 255.0.0.0.
From the workstation, open a command window and using a telnet session, connect to SANbox 6142 using IP address 10.0.0.1. Login as “guest” and use the password “password”. This will take you to a CLI prompt as shown in figure 4.
Figure 4. QLogic Router Command Line Interface
Enter CLI command “admin start”. Default password is “config”. Enter “set mgmt” at the QRouter (admin) #> prompt.
Select the mode.We recommend you use static address. Select Option 0 (Static), next enter the IP address, Subnet Mask and Gateway.
4