NPort 5600 Series User’s Manual | Web Console Configuration |
Port alias
Setting | Factory Default | Necessity |
1 to 15 characters | None | Optional |
(E.g., |
|
|
|
|
|
“Port Alias” is specially designed to allow easy identification of the serial devices which are connected to NPort’s serial port.
Serial Parameters
Check the serial communication parameters in your Serial Device’s user’s manual. You should set up NPort’s serial parameters with the same communication parameters used by your serial devices.
Baud rate
Setting | Factory Default | Necessity |
50 bps to115.2 Kbps | 115.2 Kbps | Required |
Data bits |
|
|
Setting | Factory Default | Necessity |
5, 6, 7, 8 | 8 | Required |
|
|
|
When the user sets Data bits to 5 bits, the stop bits setting will automatically change to 1.5 bits.
Stop bits
Setting | Factory Default | Necessity |
1, 2 | 1 | Required |
|
|
|
Stop bits will be set to 1.5 when Data bits is | set to 5 bits. |
|
Parity |
|
|
Setting | Factory Default | Necessity |
None, Even, Odd, Space, Mark | None | Required |
|
|
|