Installation, Rack Mounting, Desktop Mounting

Installation

RACK MOUNTING

Install the CM9700UTP Series active receiver in a standard 19-inch (48.26 cm) equipment rack using standard mounting hardware (10-32 cage nuts and 10-32 x 0.50-inch Phillips pan head screws, supplied). The receiver is one rack unit (1 RU) high.

DESKTOP MOUNTING

Install the CM9700UTP Series active receiver on a desktop using the four 8-32 x 0.25-inch Phillips pan head screws (supplied) to attach the protective bumpers to the bottom of the unit.

POWER AND VIDEO CONNECTIONS

1.Connect the power cord to the unit.

2.Connect the video input from the UTP cable to the RJ-45 connector on the back of the unit.

3.Connect the video output from the BNC to a video source.

CABLE SPECIFICATIONS

The supplied wire assembly cables are an easy connection option if patch panels are not available. The RJ-45 connector on each wire assembly plugs directly into the rear panel of the receiver. The four wire pairs on each wire assembly can be used for individual camera connections. Refer to Figure 6 on page 11 for a sample application.

Always connect the UTP wires on the cable positive to positive (+) and from negative to negative (–). For example, if you connect the blue wire to the positive (+) on the active receiver, make sure you connect the other end of the blue wire to the positive (+) on the transmitter. Figure 5 and Table A show the RJ-45 UTP pin designations.

+ - + - + - + -

Figure 5. RJ-45 Connector Pins

Table A shows the RJ-45 connector pin assignments.

Table A. RJ-45 Pin Designations

Pin	Signal	Color	Video
1	Input 1 +	White/Orange	Video 1

2	Input 1 –	Orange	Video 1

3	Input 2 +	White/Green	Video 2

4	Input 3 –	Blue	Video 3

5	Input 3 +	White/Blue	Video 3

6	Input 2 –	Green	Video 2

7	Input 4 +	White/Brown	Video 4

8	Input 4 –	Brown	Video 4

10	C3646M-C (6/09)