Sun Microsystems 805-1759-10 manual Diagnostics Testing

Page 20

3.Use the show-devscommand to list the system devices.

You should see output, similiar the following example, displayed on your screen.

ok show-devs /SUNW,ffb@1e,0 /SUNW,UltraSPARC-II@0,0 /counter-timer@1f,1c00 /pci@1f,2000 /pci@1f,4000 /virtual-memory /memory@0,60000000 /aliases

/options

/openprom

/chosen

/packages

/pci@1f,4000/SUNW,hme@4,1

/pci@1f,4000/pci108e,1000@4

/pci@1f,4000/pci@2

/pci@1f,4000/scsi@3

/pci@1f,4000/network@1,1

/pci@1f,4000/ebus@1

/pci@1f,4000/scsi@3/tape

/pci@1f,4000/scsi@3/disk

SUNW,hme identifies the Sun FastEthernet PCI Adapter Ethernet device.

network identifies the motherboard network interface.

If these devices are not listed, check that the adapter is properly seated and reinstall the adapter, if necessary.

Diagnostics Testing

For Sun FastEthernet PCI Adapter diagnostic testing, see Appendix A, “Using the selftest Diagnostics,” and refer to the SunVTS User’s Guide.

8 Sun FastEthernet PCI Adapter Installation and User’s Guide • July 1997

Image 20
Contents Sun FastEthernet PCI Adapter Installation User’s Guide Please Recycle Regulatory Compliance Statements DOC Class a Notice Avis DOC, Classe a EMC Page Contents Specifications Using the selftest DiagnosticsInterface Signals Preface How This Book Is OrganizedUnix Commands Typographic ConventionsShell Prompts Related DocumentsOrdering Sun Documents Sun Welcomes Your CommentsProduct Overview 1Sun FastEthernet PCI AdapterMedia Independent Interface MII Connector Hardware and Software RequirementsFeatures PCI Ethernet InterfacePage Installing the Sun FastEthernet PCI Adapter To Install the AdapterPage To Verify the Installation Using the Sun FastEthernet PCI AdapterVerifying the Installation Diagnostics Testing Use the show-devscommand to list the system devicesAuto-Negotiation Monitoring Network Activity Rebooting the SystemPerform a reconfiguration boot on the system Configuring Host Files To Prepare Your System for the Sun FastEthernet PCI AdapterBooting from the Network To Boot from the NetworkAt the ok prompt, type TypeIncreasing TCP/IP Performance Post-Installation Procedures OptionalConfiguring Driver Parameters Forcing Network Speed Between 10 Mbps As superuser, typeReboot your system Sun FastEthernet PCI Adapter’s local-mac-addressPropertyExternal Transceivers Using the selftest Diagnostics Ethernet FCode selftest Diagnostic Type the following to run selftest using the test commandInterface Signals Sun FastEthernet PCI Adapter ConnectorsMII Connector Signals RJ-45 Connector Signals Table B-2RJ-45 Connector SignalsPage Specifications Physical CharacteristicsPower Requirements Performance SpecificationsOrdering Sun Documents AIR Mail PAR Avion