Network Technologies DVI-x operation manual Installation

NTI UNIMUX SERIES USB KVM SWITCH

INSTALLATION

1.	It is not necessary to turn the CPUs or monitors OFF during this installation.
2.	Connect a HDMI-to-DVI cable (supplied) from a DVI monitor to the HDMI connector labeled with a monitor symbol (	)
	on the front of the UNIMUX (See Fig. 3 below.)

Front View of UNIMUX-DVI-8

Scan Broadcast Command

1 2 3 4 5 6 7 8

RS232

DDC ON

1 8

NTI

Ne twork Technologies Inc

UNIMUX TM

DVI-HDMI-MM-3 (supplied)

DVI Enabled

Monitor

Mating Face of	Mating Face of
DVI Male	HDMI Type A Male

Figure 3- Connect a DVI monitor

3.Connect the male USB type A connector on the keyboard cable to either one of the two USB type A female connectors

labeled with the USB symbol ( ) on the front of the UNIMUX.

4.Connect the male USB type A connector on the mouse cable to the remaining USB type A female connector labeled with the USB symbol on the front of the UNIMUX.

Front View of UNIMUX-DVI-8

Scan Broadcast Command

1 2 3 4 5 6 7 8

RS232

DDC ON

1 8

NTI

Network Technologies Inc

UNIMUX TM

USB Type A Male

USB Type A Female

USB Type A

Male Connectors

USB Keyboard	USB
	Mouse

Figure 4- Connect the device(s)

5