NTI VIDMUX Series
4.Plug the 5VDC AC adapter into the power jack on the rear panel.
Rear View of
Monitor | Video 2 | Video 1 | |||
|
|
|
|
|
|
5VDC 
+
NTI | R | NETWORK |
| TECHNOLOGIES | |
| INCORPORATED | |
1275 Danner Dr |
| |
Aurora, OH 44202 | ||
www.networktechinc.com
Barrel | 5 VDC |
AC |
ADAPTER
Power Connector
5VDC @ 2.0A OUTPUT
(Outside | (Inside |
barrel) | barrel) |
2.1mm x 5.5 mm Female
5.Power up the VIDMUX first.
6.Power up the monitor.
7.Power up one or both of the video sources.
Note: If one or both of the video sources is a PC, make sure the LED associated with that source is illuminated while the PC boots up. Otherwise the PC may not properly initialize with the connected monitor. See OPERATION below.
OPERATION
Press the input select buttons to switch between video sources. The LED above each button will illuminate to indicate which
source is connected to the monitor. | Only one source can be connected at a time. |
Note: While booting up a PC, it is recommended that the monitor be connected to the PC (corresponding LED should be illuminated) in order for the PC to properly initialize with the connected monitor.
Front View of
R | LED indicates | |
NetworkNTITechnologies Inc | ||
| ||
VIDMUX R | Source at | |
| VIDEO 1 | |
1 | is connected | |
2 |
3