Paradyne Installing and Cabling SFP Transceivers, Managing the MIM-2000F

3.Slide the MIM-2000F firmly into place. Do not use excessive force.

4.Secure the MIM-2000F by tightening the fastening screws on the MIM faceplate with a flat-blade screwdriver.

Installing and Cabling SFP Transceivers

Both SFP copper and fiber optic transceivers may be installed in the MIM-2000F. The following SFP fiber optic transceivers are available:

„SFP-MMF – GigE SFP Multimode Fiber Optic Transceiver, Short Reach

„SFP-SMF10 – GigE SFP Single Mode Fiber Optic Transceiver, 10Km Reach

„SFP-SMF40 – GigE SFP Single Mode Fiber Optic Transceiver, 40Km Reach

„SFP-SMF80 – GigE SFP Single Mode Fiber Optic Transceiver, 80Km Reach

		MIM-
		2000F
Lnk	1	Act
		2	Act

05-17670

To install SFP transceivers in the MIM-2000F:

Procedure

1.Insert an SFP transceiver into an SFP socket on the MIM-2000F.

2.Insert the LC connector of your fiber optic cable into the SFP transceiver.

3.Observing the minimum bend radius for your cable, fasten it in such a way that it will not be kinked or snagged in the course of other cabling. If you do not know the specifications for your cable, maintain a radius of at least ten times the cable diameter.

4.Repeat for all the sockets you intend to use.

Managing the MIM-2000F

The configuration and monitoring of the integrated switch on the MIM-2000F is performed through the management screens of the BSX8000 or 4929 DSLAM that hosts this module. See the BSX8000-5 Installation Instructions or 4929 DSLAM Installation Guide and the NMS User’s Guide.

4 June 2005 MIM2-A2-GZ42-00