Paradyne ENE2020-P installation instructions LED Indicators, Led

LED Indicators

This document describes units manufactured after 13 January 2005. See the prior version of this document for information about units manufactured on or before that date.

Whenever both ENE2020 E1 connections have lost link or have presented an E1 Alarm, the Ethernet link will automatically be disabled (as indicated by no illumination of the Ethernet 100, Act and Lnk LEDs). Upon reestablishment of at least one of the E1 connections, the Ethernet link will be reinstated and the Ethernet LEDs will reflect current Ethernet Status.

Table 6. LEDs (1 of 2)

LED	State	Indication	Additional Information
E1	Flashing*	E1 connection is	Traffic is flowing.
Connections	Green	established and active
Lnk (Port 1
	Solid	Problematic E1	A connection exists but there
and Port 2)
	Green	connection	is indication of a problem with
			the E1 line.
	No	Loss of Synchronization	If the outgoing connection
	Illumination	(LOS)The incoming	from the unit has also been
		connection to the unit	lost then the unit's partner
		has been lost; no data is	ENE2020 will have LOS as
		being received.	well.
E1	No	E1 is operational	An established E1 link has no
Connections	Illumination		alarm indications and is
Alm (Port 1			operational unless the E1 Lnk
and Port 2)			LED remains unlit as well, in
			which case the ENE2020 has
			LOS.
	Solid	Remote Alarm Indication	The unit's partner ENE2020
	Amber	(RAI)The outgoing	has lost its incoming
		connection from the unit	connection and has LOS.
		has been lost; no data is
		being transmitted.
	Pulsing*	Alarm Indication Signal	The unit's partner ENE2020
	Amber	(AIS)An indirect	has lost a connection with an
		connection has been	intermediate device and has
		lost; the unit may no	LOS or RAI.
		longer be receiving data
		from its partner
		ENE2020.

10