Paradyne 8785 installation instructions 99-16544

—For a Hotwire 8800 Series DSLAM – Hold the unit vertically, with the component side facing right, and insert it into the top and bottom card guides.

POWER ALARMS

A B Fan Major Minor

																SYSTEM
																	OK
																	Alm
																	Test
SYSTEM																ETHERNET
																	TX
OK																	RX
Alrm																	Coll
Test
SYNC
PORT1
2
3
4
DSL
LINKPORT-
UP1
2
3
4
																MCC
M/HDSL
8785
				-48V INPUT						LAN/WAN SLOT			16		20	MGT
SLOTS 13-18						2	4	6	8	10	12	14		18		SERIAL
SLOTS	7-12	LINES			GNDFR
			48V- (A)	48V- (B) RET(A) RET(B)						LAN/WAN SLOT						10BT
SLOTS	1 - 6	A	B			1	3	5	7	9	11	13	15	17	19	MGT	ALARM

99-16544

4.Slide the unit into the slot until the power and network connectors seat firmly in the mating connectors on the backplane.

CAUTION:

Do not force the unit into the slot. This could damage the backplane connectors. If the card does not seat properly, remove the card and reinstall it. If it still does not seat properly, call your service representative.

The unit performs a power-on self-test. All of the LEDs turn ON and OFF briefly. When the self-test is completed successfully, the SYSTEM OK LED begins to pulse.

5.If the LED is not pulsing, refer to Messages and Troubleshooting in the User’s Guide.

6.Secure the unit by fastening the screws at each end of the faceplate.

5