Paradyne 7511 technical manual Installing the Rear Connector Plate

Page 8

Installing the Rear Connector Plate

"Procedure

To install the rear connector plate:

1.At the rear of the carrier, place the tab on the connector plate in its slot in the carrier's backplane. The connector plate must use the same slot position intended for the DSU card.

2.Loosely fasten the screw, allowing for a slight adjustment when installing the DSU card.

25-Pin

DTE Connectors

P21

V.35

97-15484

January 1999

7511-A2-GN10-10

Image 8

Contents Preparation Package ChecklistProduct Documentation on the World Wide Web Installing the Dual DSU Cables You May Need to OrderLine Rate Off KbpsConfiguration Options 2 Switch Options and Usage Configuration Options 3 Switch Options and Usage Configuration Options 4 Switch Options and Usage Off Off StandardOff Constant Off StandardConfiguration Options 5 Switch Options and Usage Installing the Rear Connector Plate Installing the DSU Card Circuit Pack Lock495-14797 Installing the Network and DTE Cables Troubleshooting Symptom Possible Cause RecommendationsImportant Safety Instructions January Government Requirements DDS Facility Interface Code Data RateWarranty, Sales, and Service Information Copyright E 1999 Paradyne Corporation