Patton electronic 2073RC user manual No connection

Page 16

4 pulses = IMRC2/IAbuffer is saturated

5 pulses = WAN receive frame(s) too large

6 pulses = WAN receive frame(s) not Octet aligned

7 pulses = WAN receive frame(s) aborted

8 pulses = Detected WAN receive frame(s) with bad CRC

9 pulses = Detected LAN receive frame(s) too large

10 pulses = Detected LAN receive frame(s) not Octet aligned

11 pulses = Detected LAN receive frame(s) with bad CRC

After a status code is displayed eight times and the associated condition is removed, the status code will no longer appear.

Link. Glows green to indicate good link integrity on the 10Base-T twisted pair line.

The RJ-45 Ethernet port on Ethernet Bridge Module is designed to con- nect directly to a 10Base-T network. Figure 8 shows the 10Base-T RJ-45 port pin description. You may make connections up to 330 feet using Type 4 or 5 cable.

 

1

(no connection)

1

2

(no connection)

3

(4-Wire ARX-)

2

3

4

(2-Wire TIP)/(4-Wire TX+)

4

 

 

55 (2-Wire RING)/(4-Wire TX-)

6

6

(4-Wire ARX+)

7

8

7

(no connection)

 

8

(no connection)

Figure 8. Model IMRC2/IA Ethernet Connector Pinout

Connecting to the network. The Line Interface is an 8-position keyed modular jack configured as an RJ-48C (see. Figure 9). This interface will connect to a 64 kbps/G.703, co-directional network running AMI line coding.

 

1

RX data (TIP)

From network

 

2

RX data (RING)

1

 

3 (no connection)

 

2

 

3

4 TX data (TIP)

To network

4

5 TX data (RING)

5

 

6

6 (no connection)

 

7

 

8

7 (no connection)

 

8 (no connection)

Figure 9. 64 kbps Network Interface

16

Image 16
Contents User Manual Contents Interface Pin Assignment Radio and TV Interference Warranty InformationCE Notice Tel +1 301 Email support@patton.com ServiceUTC-5, Monday through Friday General Information FeaturesDescription Configuration Model 2073RC top view showing location of DIP switchesConfiguring the Front Interface Card OFFSwitches SW3-5 Front panel switch enabled/disabled Switch SW3-4 Response to Remote digital RDL LoopbackSW3-6 Activation Description SW3-4 DescriptionConfiguring the Rear Interface Card Model 2073RC Series interface card optionsOrientation of Interface Card Straps Model 1001RCM13448C Strap Settings Strap Function Position 1&2 Position 2&3Model 1001RCM11548C Strap Settings Position DescriptionFrgnd & Sgnd Pin Model IM2RC/IA 10Base-T Ethernet Rear Card IM2RC/A, rear panel optionsNo connection Page Rack Power Supply InstallationModel 1001R14 Rack Chassis Powering up your 1001R14 rack Installing the Model 2073RC Into the ChassisConnecting to a DTE Device Connecting to a DCE DeviceConnecting to a G.703/64 Kbps Network NetLink-E1 twisted-pair interfaceOperation LED DescriptionsLoop V.54 & Telco Diagnostics Operating Local Loopback LLBBit Error Rate V.52 Diagnostics Operating Remote Digital Loopback RDLDiagnostics LED Status IndicatorsConnectors Temperature RangeInterface 34F Female Connector DCE Configuration Pin # Signal Appendix BFrame Ground Page Copyright Patton Electronics Company All Rights Reserved