Patton electronic Configuration, Model 2073RC top view showing location of DIP switches

Page 7

3.0 CONFIGURATION

The 2073RC features configuration capability via hardware DIP switches. This section describes all possible hardware switch configuration. Figure 1 shows the location of the DIP switches on the top of the printed circuit board

Figure 1. Model 2073RC top view showing location of DIP switches

Figure 2 shows the orientation of the DIP switches with respect to ON/ OFF positions.

ON

1 2 3 4 5 6 7 8

ON

OFF

Figure 2. Close-up of DIP switches showing ON/OFF positions

7

Image 7
Contents User Manual Contents Interface Pin Assignment Radio and TV Interference Warranty InformationCE Notice Tel +1 301 Email support@patton.com ServiceUTC-5, Monday through Friday General Information FeaturesDescription Model 2073RC top view showing location of DIP switches ConfigurationOFF Configuring the Front Interface CardSW3-4 Description Switches SW3-5 Front panel switch enabled/disabledSwitch SW3-4 Response to Remote digital RDL Loopback SW3-6 Activation DescriptionModel 2073RC Series interface card options Configuring the Rear Interface CardOrientation of Interface Card Straps Strap Function Position 1&2 Position 2&3 Model 1001RCM13448C Strap SettingsPosition Description Model 1001RCM11548C Strap SettingsFrgnd & Sgnd Pin IM2RC/A, rear panel options Model IM2RC/IA 10Base-T Ethernet Rear CardNo connection Page Rack Power Supply InstallationModel 1001R14 Rack Chassis Connecting to a DCE Device Powering up your 1001R14 rackInstalling the Model 2073RC Into the Chassis Connecting to a DTE DeviceNetLink-E1 twisted-pair interface Connecting to a G.703/64 Kbps NetworkLED Descriptions OperationOperating Local Loopback LLB Loop V.54 & Telco DiagnosticsOperating Remote Digital Loopback RDL Bit Error Rate V.52 DiagnosticsTemperature Range DiagnosticsLED Status Indicators ConnectorsAppendix B Interface 34F Female Connector DCE Configuration Pin # SignalFrame Ground Page Copyright Patton Electronics Company All Rights Reserved