Patton electronic 1093 user manual Features, Description, External DIP Switch Settings

2.0 GENERAL INFORMATION

Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warrant- ed for One Year parts and labor. If any questions or problems arise during installation or use of this product, please do not hesitate to con- tact Patton Electronics Technical Support at (301) 975-1007.

2.1 FEATURES

•Synchronous data rates of 256 and 512 kbps

•Frequency Shift Key (FSK) modulation

•Full or half duplex operation over two twisted pair (4-wire)

•Point-to-point distances up to 6 miles (19 AWG @ 256 kbps)

•V.54 compliant local and remote loopback tests (DTE or front panel activated)

•V.52 compliant Bit Error Rate (BER) test pattern generator

•Replaceable DTE-DCE QuickConnect™ interface modules

•Internal, external or receive recovered clocking options

•Automatic equalization

•Made in the U.S.A.

2.2 DESCRIPTION

The Patton Model 1093 Synchronous Short Range Modem is designed for point-to-point, high speed communication over 4-wires (two twisted pair). Supporting switch-selectable data rates of 256 and 512 kbps, the Model 1093 is perfect for connecting two bridge/routers, or for similar campus applications at distances up to 6 miles (9.6 km). The Model 1093 incorporates built-in V.54 loopback tests, a V.52 BERT pattern generator and seven front panel LED indicators. Data integrity is enhanced by automatic equalization and gain control. The Model 1093 also incorporates transformer isolation and surge protection to guard data and connected equipment against the hazards of ground loops and transient surges. Clocking options include internal, external and receive recover clock.

The Model 1093 features replaceable DCE-DTE QuickConnect™ interface modules. Several different modules are available (call Patton Sales for details). Line connection is made by RJ-45 jack. Internal AC power supply options include 120 or 230VAC (switchable), 85-256VAC (universal) or 48VDC.

3.0 CONFIGURATION

The Model 1093 is equipped with one set of eight DIP switches, and one set of four DIP switches (all externally accessible). These DIP switches allow configuration of clock source, carrier control, loopback tests and data rate. This section describes switch locations and explains all possible configurations.

3.1 EXTERNAL DIP SWITCH SETTINGS

The Model 1093’s DIP switches are located on the underside of the unit (see Figure 1, below). Figure 2 shows the orientation of the switch set. All possible settings for the Model 1093’s DIP switches are presented in the summary table and descriptions on the following pages.

REAR

S1

S2

8	7	6	5	4	3	2	1	4	3	2	1
							ON			ON

FRONT

Figure 1. Underside of Model 1093 Showing External DIP Switch Locations

				S1						S2
ON	ON								ON
	1	2	3	4	5	6	7	8	1	2	3	4	OFF
	Figure 2. Close Up of Configuration Switches

3 4