3.2 CONNECTING POWER (EUI MODELS)
The Interconnecting cables shall be acceptable for
external use and shall be rated for the proper applica-
tion with respect to voltage, current, anticipated tem-
CAUTION perature, flammability, and mechanical serviceability.
The Model 2110 does not have a power switch, so it powers up as soon as it is plugged in.
An external AC or DC power supply is available separately. This connec- tion is made via the barrel jack on the bottom panel of the Model 2110. No configuration is necessary for the power supply (See Appendix B for domestic and international power supply and cord options). DC power (supplied via the power supply jack to the 2110) must meet the following requirements; DC power supplied must be regulated +12VDC ±5%, 1.0A minimum. Center pin is +12V. The barrel type plug has a 2.5/5.5/10mm I.D./O.D./Shaft Length dimensions.
4.0 OPERATION
Once the Model 2110 is properly installed, it should operate transpar- ently. No user settings required.
4.1 POWER UP
Models 2110/PSE and 2110/EUI: Before applying power to the Model 2110, please review section 3.2, “Connecting Power (EUI Models)” on page 9 to verify that the unit is connected to the appropriate power source.
9