Patton electronic 2112 user manual Radio and TV Interference, CE Notice

Page 2

 

TABLE OF CONTENTS

 

 

SECTION

PAGE

1.0

Warranty Information

2

 

1.1 Radio and TV Interference

 

 

1.2. CE Notice

 

 

1.3 Service

 

2.0

General Information

4

2.1Features

2.2Description

2.3Typical Application

3.0 Installation

6

3.1Connecting the Twisted Pair Line Interface

3.2Connecting the 10BaseT Ethernet Interface

3.3Connecting Power

4.0 Operation

10

4.1Power- Up

4.2Front Panel LED Status Monitors

4.3Ethernet LED Status Monitors

4.4Test Modes

Appendix A - Specifications

14

Appendix B - Factory Replacement Parts and Accessories

15

Appendix C - Interface Pin Assignments

16

Appendix D - Control Port Pin Assignment

37

1.0 WARRANTY INFORMATION

Patton Electronics warrants all Model 2112 components to be free from defects, and will—at our option—repair or replace the prod- uct should it fail within one year from the first date of shipment.

This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modifi- cation. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above. Under no condition shall Patton Electronics be liable for any damages incurred by the use of this product. These damages include, but are not limited to, the following: lost profits, lost savings and incidental or consequen- tial damages arising from the use of or inability to use this product. Patton Electronics specifically disclaims all other warranties, expressed or implied, and the installation or use of this product shall be deemed an acceptance of these terms by the user.

1.1 RADIO AND TV INTERFERENCE

The Model 2112 generates and uses radio frequency energy, and if not installed and used properly—that is, in strict accordance with the manufacturer's instructions—may cause interference to radio and tele- vision reception. The Model 2112 has been tested and found to com- ply with the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection from such interference in a commercial installation. However, there is no guarantee that interfer- ence will not occur in a particular installation. If the Model 2112 does cause interference to radio or television reception, which can be deter- mined by disconnecting the unit, the user is encouraged to try to cor- rect the interference by one or more of the following measures: mov- ing the computing equipment away from the receiver, re-orienting the receiving antenna and/or plugging the receiving equipment into a differ- ent AC outlet (such that the computing equipment and receiver are on different branches).

1.2 CE NOTICE

The CE symbol on your Patton Electronics equipment indicates that it is in compliance with the Electromagnetic Compatibility (EMC) directive and the Low Voltage Directive (LVD) of the European Union (EU). A Certificate of Compliance is available by contacting Technical Support.

1

2

Image 2
Contents User Manual Radio and TV Interference CE NoticeTel Email support@patton.com ServiceFeatures DescriptionConnecting the Twisted Pair Line Interface Typical ApplicationSignal PIN Connecting the 10BASET Ethernet InterfaceFront Panel LED Status Monitors Connecting PowerPOWER-UP TD & RDEthernet LED Status Monitors Test ModesPatton Electronics Model 2112 Specifications Patton Electronics Model # Description Model 2112 Interface PIN AssignmentLine Interface Pin Description RJ-45 Female Connector Dear Valued Customer