Patton electronic IM2RC/F Table of Contents, Warranty Information, Radio and TV Interference

Page 2

 

 

TABLE OF CONTENTS

 

 

Section

Page

1.0

Warranty Information

2

 

1.1

Radio and TV Interference

 

 

1.2

CE Notice

 

 

1.3

Service Information

 

2.0

General Information

4

2.1Product Features

2.2General Product Description

3.0 Configuration

5

3.1Configuring the IM2RC/F Hardware Switches

3.2Connecting the Interface Driver Board

4.0 Installation

9

4.1The Model 1000R16 Rack Chassis

4.2Installing the Rear IM2RC/F Card and Front Function Card

4.3Making Interface Connections

5.0 Operation

14

5.1Typical Application

5.2Operating Instructions

Appendix A - Specifications

15

Appendix B - Factory Replacement Parts and Accessories

16

Appendix C - 120 Ohm G.703 Inteface Pin Assignment

17

Appendix D - Line Interface Assignment

18

1.0 WARRANTY INFORMATION

Patton Electronics warrants all Model IM2RC/F components to be free from defects, and will—at our optio n—repair or replace the product should it fail within one year from the first date of shipment.

This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modification. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above. Under no condition shall Patton Electronics be liable for any damages incurred by the use of this product. These damages include, but are

not limited to, the following: lost profits, lost savings and incidental or consequential damages arising from the use of or inability to use this product. Patton Electronics specifically disclaims all other warranties, expressed or implied, and the installation or use of this product shall be deemed an acceptance of these terms by the user.

1.1 RADIO AND TV INTERFERENCE

The Model IM2RC/F generates and uses radio frequency energy, and if not installed and used properly—that is, in strict accordance with the manufacturer's instructions—may cause interference to radio and television reception. The Model IM2RC/F has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection from such interference in a commercial installation. However, there is no guarantee that interference will not occur in a particular installation. If the Model IM2RC/F does cause interference to radio or television reception, which can be determined by disconnecting the unit, the user is encouraged to try to correct the interference by one or more of the following measures: moving the computing equipment away from the receiver, re-orienting the receiving antenna and/or plugging the receiving equipment into a different AC outlet (such that the computing equipment and receiver are on different branches). In the event the user detects intermittent or continuous product malfunction due to nearby high power transmitting radio frequency equipment, the user is strongly advised to use only data cables with an external outer shield bonded to a metal or metalized connector at both ends. Shielded cables must be used on the network connection to satisfy compliance with the Electromagnetic Compatibility (EMC) directive.

1

2

Image 2
Contents User Manual Radio and TV Interference Table of ContentsWarranty Information CE Notice ServiceFeatures General InformationPosition Function Factory Default Configuration Configuring the IM2RC/F Hardware SwitchesSwitch Summary Table Switch S2 Operation ModeConnecting the Interface Driver Board Switches S3 Timing ModeSwitch S6 Operation Mode Installing the Rear IM2RC/F Card and Front Function Card Installation Model 1000R16 Rack ChassisRack Power Supply Making Interface Connections Connecting to a G.703 PCM Network ChannelConnecting the Line Interface Signal PIN# Operation Two-Wire and Four-Wire Cable Connection Via RJ-45Signal PIN# Typical ApplicationPatton IM2RC/F SpecificationsAppendix a Appendix B Patton IM2RC/F Cable RecommendationsRJ45 Female Connector Pin Number Signal Patton Model # DescriptionCopyright Patton Electronics Company All Rights Reserved