Patton electronic user manual JP1 and JP2 locations for 460M

Page 7

JP1

Figure 3. JP1 and JP2 locations for 460M

2.Using Figure 2 as a reference, remove the desired jumper(s) to break one or both shield connections.

Note Do not lose the jumper(s).

3.Align the case halves and end inserts and snap the case halves back together.

Image 7

Contents User Manual Contents Service and Support CE Notice Warranty InformationProduct Description Shielded RJ-45 Jack RJ-45 Jack and Terminal Block DescriptionsTerminal Block Pin 6 RX Shield ConfigurationRJ-45 120 ohm Jumper Coax BNC 75 ohm Pin 3 TX Shield TX Out ShieldJP1 and JP2 locations for 460M Installing the Model 460-TBP InstallationInstalling the Model RJ-45 Pins FunctionTwisted-pair CPECoax Appendix a Power SupplyOperating Temperature Dimensions